The objective of this study was to evaluate the concentration of Cu, Zn, Cr and Pb in different species of fish collected in the estuarine and limnic regions of the São Gonçalo channel, located in the Patos-Mirim lagoon complex in the coastal plain of Rio Grande do Sul State (Southern Brazil) during 2013 (autumn, winter and spring) and 2014 (summer). Fish samples were decomposed in a digester block with a reflux system under conditions optimized using a central composite design as it follows: 250 mg of fish sample, 5 mL HNO3, 2 mL H2O2 during 2 h at 150 °C. The concentrations obtained ranged from 6.7 to 12.0 mg kg -1 for Cu; 1.8 to 23.6 mg kg -1 for Zn; 37 to 487 µg kg -1 for Pb; and 40 to 1268 µg kg -1 for Cr. The highest concentrations of Cu, Zn and Pb, were observed in fishes collected at locations in the estuarine region and Cr showed high levels, especially in the limnic region. The samples of the species Loricariichthys anus (viola) showed the highest concentrations of all analytes investigated.

ABSTRACT: Pollination depends on morphological and behavioural adjustments between visitors and plants. Some plant species as Ipomoea bahiensis (Convolvulaceae) provide nectar and pollen to visitors and occur in anthropic areas, therefore becoming an important source of resources for the maintenance of native pollinating insects. However, what is the efficiency of each floral visitor species for the pollination of this plant species? What morphological and behavioural characteristics determine the pollinators? In this regard, this study evaluated the I. bahiensis flower and visitor morphology in a semi-arid area and the foraging behaviour of these floral visitors. Also, the efficiency rate of potential pollinators was quantified. Bees and butterflies visited the flowers of I. bahiensis, but the bees Melitoma spp., Apis mellifera (Linnaeus, 1758), and Pseudaugochlora pandora (Smith, 1853) were the most frequent visitors. These species presented medium-sized and compatible with the floral tube width. In addition to the size, these bees presented behaviour that favoured the contact with the reproductive structures of the flower, as evidenced by the efficiency test of the flower visits. Although butterflies often collect nectar from the flowers, they do not present characteristics that could result in pollination. Hence, medium-sized bees played the role of efficient pollinator of I. bahiensis.

This paper presents a study involving the development of a new mini polytetrafluoroethylene (PTFE) vessel project for biological sample preparation in micro scale in closed system with microwave radiation for subsequent determination of Cd, K, Mg and Na by atomic spectrometry techniques. All experiments were carried out in micro quantities of samples (up to 20 mg) and reagents (300 µL of HNO3) for 5 min at 350 W. Certified reference materials of biological samples (bovine muscle and liver) were used to evaluate the accuracy of the proposed system and the results obtained were in agreement with the certified value at 95% of confidence (t -test). Relative standard deviations (RSD) were lower than 8.0% for all elements. The proposed method is not only easy and fast, but it is also based on the use of an inexpensive system for sample digestion.

This paper describes the optimization of a sample preparation method using response surface methodology for Al, Cd, Cu, Fe, Mg, Mn, Mo, Na, Ni and Ti determinations in samples of rice husk and rice husk ash by MIP OES. Sample preparation was performed using a reflux system adapted to the digestion tubes. This system allowed the decomposition of the samples without the necessity of replacement of the acids during this step without any loss of volatile elements. The decompositions were performed with 3.6 mL of HNO3 and 1.4 mL of H2SO4 for 205 min in a digester block at 225 ºC. The detection limit for determination of respective analytes in both samples were satisfactory. The RSDs for the analytes were less than 10%. Moreover, the accuracy of the method can be verified by recovery tests, whose values ranged from 82 to 115% for husk samples and 82 to 120% for ashes. The proposed method was presented as a simple, safe and low cost procedure being suitable for sample preparation and subsequent determination of metals by MIP OES.

In this work, two sample preparation procedures for subsequent determination of Na, K, Ca and Mg by techniques of atomic spectrometry in samples of Brazilian cream cheese were evaluated. The determinations were performed on two equipments, F AAS and MIP OES, which presented similar results, being evident the advantages of MIP OES since it is a multielementar technique with low operational cost and high efficiency. The first procedure was carried out by acidic decomposition (HNO3/H2SO4) in a reflux system, and the second used the alkaline solubilization with tetramethylammonium hydroxide. The accuracy was verified by recovery tests and the results were between 80 and 104% for both procedures. A comparison with a reference procedure was also performed and no significant differences have been observed at the 95% confidence level. The evaluated elements were not in accordance with the values indicated on the labels of all products, showing the importance for monitoring these products. The methods of sample preparation proposed showed to be simple, inexpensive, providing accurate and precise results, and are a promising alternative to be used for the quality control of these routine test samples.

This paper describes the method optimization using response surface methodology for Cu, Fe, Zn and Na determinations in coal and ash samples by spectrometry techniques. The sample preparation was performed using a recirculation system adapted in the digestion tubes. This system allowed increase of temperature in the digester block above the boiling point of the reaction medium, avoiding acid evaporation during the heating. The digestions were realized with HNO3 and H2O2 for 1 h in a digester block at 145 °C. The limits of detection for determination of Cu, Fe, Zn and Na in both samples were satisfactory. The RSD for the analytes were lower than 6.0%. Statistical tests showed that results for all analytes do not vary significantly with official method (ASTM), considering a confidence limit of 95%. Besides, the accuracy was verified by recovery tests, whose values ranged from 92.7 to 104.7% in coal, and 98.7 to 115.3% in ash.

The objectives were to determine seed biometrics, recording cellular respiration in the imbibition process, evaluate the effect of inducing chemicals in germination and early growth analysis. Cellular respiration during imbibition was measured by reduction of methylene blue and Janus Green B. The inductor effect of five chemical compounds in germination was evaluated. Initial growth was recorded by stereoscopic. Results showed that the seeds have an average weight of 520 ± 172 mg, length of 13.50 ± 1.76 mm, width of 10.61 ± 1.14 mm, and thickness of 4.68 ± 0 62 mm. These variables showed significant correlations (r of 0.494 to 0.897 and p <0.001). Seeds were metabolically active during imbibition, which was evidenced by reduction of both electronic acceptors. Sodium nitrite and potassium cyanide induced germination of seeds in >90% and 65% respectively. Seedling initial growth consisted of six stages and occurred over a period of 22 days after radicle emergence. In conclusion, M. dubia seeds show wide variation in their biometrics (weight, length, width and thickness), but show significant correlations with each other. Likewise, seeds are metabolically active in imbibition process, and germination is induced by sodium nitrite and potassium cyanide. Furthermore, seedling initial growth to occur over a period of 22 days after emergence of the radicle and consists of six distinct stages.

Los objetivos planteados fueron determinar la biometría de las semillas, registrar la respiración celular en el proceso de imbibición, evaluar el efecto inductor de la germinación de compuestos químicos y analizar el crecimiento inicial. La respiración celular durante la imbibición se midió por reducción del azul de metileno y del Janus Green B. El efecto inductor de la germinación de cinco compuestos químicos fue evaluado. El crecimiento inicial se registró con estereoscopio. Los resultados mostraron que las semillas tienen en promedio un peso de 520±172 mg, largo de 13,50±1,76 mm, ancho de 10,61±1,14 mm y espesor de 4,68±0,62 mm. Estas variables mostraron correlaciones significativas (r de 0,494 a 0,897 y p < 0,001). Las semillas fueron metabólicamente activas durante la imbibición, el cual se evidenció por la reducción de ambos aceptores electrónicos. El nitrito de sodio y el cianuro de potasio indujeron la germinación de las semillas en >90% y 65% respectivamente. El crecimiento hasta plántula constó de seis etapas y ocurrió en un periodo de 22 días después del brote de la radícula. En conclusión, las semillas de M. dubia muestran una amplia variación en sus datos biométricos (peso, largo, ancho y espesor), pero muestran correlaciones significativas entre sí. Asimismo, las semillas son metabólicamente activas en el proceso de imbibición y su germinación es inducida por el nitrito de sodio y el cianuro de potasio. Además, el crecimiento inicial hasta plántula ocurre en un periodo de 22 días después del brote de la radícula y consta de seis etapas bien diferenciadas.