It is reported the design, construction and initial tests of a three cell flying capacitor inverter (TCFCI) in a half-bridge configuration. The device operates at a 200 kHz frequency which leads to a voltage output at 12.5 kHz presenting an acceptable response in an open-loop configuration. These features outdo those reported in the current multilevel converter literature. The TCFCI is driven by pulse width modulation, following a phase shift (PS-PWM) control strategy, in order to generate a steady AC voltage signal. This inverter is used to excite a dielectric barrier discharge cell (DBDC) intended for cold plasma generation at room pressure. Some results obtained for two different kinds of atmosphere, helium and argon, are presented. All the system having been tested, early recorded voltage and current waveforms, are included. Finally, three methods for calculating the related electric efficiency of the discharge cell are discussed.

Samples of pure Titanium were treated by means a PIII process using a dense DC glow discharge with different mixtures of nitrogen-oxygen and oxygen pure. The surface of treated samples was analyzed by means of different techniques such as X-ray diffractometry, Scanning Electron Microscope, Vickers Microhardness tester and profilometer. We conclude that the modified surface is formed by TiN0.26 diffused into TiO2 in rutile phase, forming a uniform layer up to 10 μm in thickness and whose resultant microhardness is almost five times greater than that of untreated titanium. Some control over the superficial parameters is taken by varying the proportion of nitrogen-oxygen at a pressure of 1x10-2 Torr (~1.33 Pa), obtaining a thicker layer, a harder surface or a reduced roughness. The identified phases have biocompatible properties, which provide interest in the bioengineering field.

One alternative application in the decomposition and destruction of volatile organic compounds (VOCs) by a silent plasma dielectric barrier discharge (DBD) has been successfully accomplished. For this purpose, we have designed and constructed two pairs of cells, of rectangular and circular geometries, 333.96 cm³ each cell, and a similar second pair of 62.25 cm³ each one. Resonant inverters for low (3.3 kHz) and high (100 kHz) frequencies were also designed and applied to these cells. The specification of the main physical parameters of each cell contemplates: i) a first order degradation ratio of the compound, and ii) air breakdown at atmospheric pressure as a function of the carrying gas. The power consumed by the cells during the discharges was computed both theoretically and experimentally by Manley's method. The equipment was applied to the degradation of toluene, which has been degraded by an oxidation process in air-oxygen and argon-oxygen gas mixtures at atmospheric pressure within the cells. The destruction efficiency was measured as a function of the initial concentration. When air is used as an oxidant, a clear formation of solid products on the walls of dielectric glass plates has been observed, such deposits being polymeric in nature. These deposits seem to be responsible for a decline in the degradation efficiency of the treated compounds.