Abstract Epoxidized sunflower oil (ESO) and epoxidized sunflower oil methyl ester (ESOME) were synthetized and employed as secondary bio based plasticizers and combined with primary natural plasticizers. As such, di-esters isosorbide (DEI) and acetyl tributyl citrate (ATBC) used in Poly Vinyl Chloride (PVC) as compared to di-(2-ethylhexyl) phthalate (DEHP). PVC Sheets were obtained by processed the polymer and its additives on two-roll mill. The effect of the plasticizers combination on flexible sheets properties, including stabilization, migration, fusion rheological properties and light transmission have been discussed, Results have shown that ESO and ESOME have improved PVC formulations thermal stability, the weight loss by volatility has decreased in the formulations which contained ESO or ESOME. Mixtures of plasticizers have lower migration rates. Plastograph test has indicated a better compatibility of PVC with these plasticizer mixtures. The light transmission rate through PVC sheets plasticized by bio-based plasticizers mixtures is more than those containing DEHP.

Abstract The use of mixtures of nontoxic and biodegradable plasticizers coming from natural resources is a good way to replace conventional phthalates plasticizers. In this study, two secondary plasticizers of epoxidized sunflower oil (ESO) and epoxidized sunflower oil methyl ester (ESOME) were synthesized and have been used with two commercially available biobased plasticizers; isosorbide diesters (ISB) and acetyl tributyl citrate (ATBC) in order to produce flexible PVC. Different mixtures of these plasticizers have been introduced in PVC formulations. Thermal, mechanical and morphological properties have been studied by using discoloration, thermogravimetric analysis (TGA), differential scanning calorimetry (DSC), dynamic mechanical thermal analysis (DMTA), tensile - strain and scanning electron microscopy (SEM). Studies have shown that PVC plasticization and stabilization were improved by addition of plasticizers blends containing ISB, ATBC, ESO and ESOME. An increase in the content of ESO or ESOME improved thermal and mechanical properties, whereas ESOME/ATBC formulations exhibited the best properties.

Polylactic acid (PLA) is an attractive candidate for replacing petrochemical polymers because it is from renewable resources. In this study, a specific PLA 2002D was melt-mixed with two plasticizers: triethyl citrate (TEC) and acetyl tributyl citrate (ATBC). The plasticized PLA with various concentrations were analyzed by differential scanning calorimetry (DSC), dynamic mechanical analysis (DMA), melt flow index (MFI), thermogravimetric analysis (TGA), X-ray diffraction (XRD), UV-Visible spectroscopy and plasticizer migration test. Differential scanning calorimetry demonstrated that the addition of TEC and ATBC resulted in a decrease in glass transition temperature (Tg), and the reduction was the largest with the plasticizer having the lowest molecular weight (TEC). Plasticizing effect was also shown by decrease in the dynamic storage modulus and viscosity of plasticized mixtures compared to the treated PLA. The TGA results indicated that ATBC and TEC promoted a decrease in thermal stability of the PLA. The X-ray diffraction showed that the PLA have not polymorphic crystalline transition. Analysis by UV-Visible spectroscopy showed that the two plasticizers: ATBC and TEC have no effect on the color change of the films. The weight loss plasticizer with heating time and at 100°C is lesser than at 135 °C. Migration of TEC and ATBC results in cracks and changed color of material. We have concluded that the higher molecular weight of citrate in the studied exhibited a greater plasticizing effect to the PLA.