Abstract The discovery of new mineral resources involves various research techniques through direct and indirect studies. The geophysical methods are important tools in the detection of deep deposits because they use the contrast between the physical properties of the hosting rocks and the mineralized zone. In this sense, electrical geophysical methods are widely used in the prospecting of sulfide deposits. This work presents and discusses the results of the application of the Induced Polarization geophysical method in the investigation of a tin mineral occurrence associated with greisen, located on the western border of São Sepé Granite. The study area is located in the central portion of the Rio Grande do Sul State, in the municipality of São Sepé (RS), housed in the metavolcano-sedimentary rocks of the Vacacaí Metamorphic Complex. Six lines of electrical tomography were parallel arranged in the N30W direction. The 2D inversion models allowed to identify areas of high chargeability (above 5.0 mV/V), possibly attributed to areas with sulfide accumulation. The areas with low values (below 1.9 mV/V) area associated with soil and rocks absent of mineralization. Through the 3D visualization models, it was possible to identify that the mineralized zone apparently has continuity for more than 36 m. These models also allowed identifying the morphology and the lateral continuity of the sulfide zone. Thus, the results of this work demonstrate the possibility of using Induced Polarization in the research of cassiterite deposits with associated sulfides due to the contrast of physical properties obtained from the high polarizability of the sulfides.

Abstract Ore mining fundamentally depends on the definition of its tenor and volume, something extremely complex in disseminated mineralization, as in the case of certain types of deposits of gold and sulfites. This article proposes the use of electrical tomography for definition of a geophysical signature in terms of electrical resistivity and chargeability, in an outcrop of mineralized quartz lode at the end of an inactive gold mine. One of the targets was to analyze the continuity of the mineralized body, the occurrence of new outcrops and the applicability of the method as an auxiliary tool in mineral extraction. Three parallel lines of electrical tomography in a dipole-dipole arrangement, being orthogonal to the orientation of the gold lode, were installed in an area outside the mine. The results allowed the geophysical characterization of the mineralized zone by high resistivity (above 1000Ω.m) and high chargeability (above 30mV/V). The results of the 2D inversion models were interpolated in 3D visualization models, which allowed definition of the contour surfaces for the physical parameters measured, and the morphological pattern modeling of the mineralization. The data reveal the existence of a new lode in subsurface, localized 30m to the south of the lode outcrop. The versatility of the acquisition and data processing indicate the application potential of electrical tomography as a criterion for sampling and tenor definition in ore extraction activities, since it is objective and low cost.