Insecticide effects of deltamethrin 2.5% SC (flowable solution) on different substrates and triatomine infestation rates in two indigenous villages (Estancia Salzar and Nueva Promesa) of the Paraguayan Chaco are reported. This field study was carried out to determine the extent to which variability in spray penetration may affect residual action of the insecticide. A total of 117 houses in the two villages were sprayed. Filter papers discs were placed on aluminium foil pinned to walls and roofs in selected houses and the applied insecticide concentration was determined by high pressure liquid chromatography (HPLC). The target dose rate was 25 mg a.i./m². The mean actual applied dose in Estancia Salazar was 11.2 ± 3.1 mg a.i./m² in walls and 11.9 ± 5.6 mg a.i./m² in roofs while in Nueva Promesa, where duplicates were carried out, the mean values were 19.9 ± 6.9 mg a.i./m² and 34.7 ± 10.4 mg a.i./m² in walls and 28.8 ± 19.2 mg a.i./m² and 24.9 ± 21.8 mg a.i./m² in roofs. This shows the unevenness and variability of applied doses during spraying campaigns, and also the reduced coverage over roof surfaces. However, wall bioassays with Triatoma infestans nymphs in a 72 h exposure test showed that deposits of deltamethrin persisted in quantities sufficient to kill triatomines until three months post spraying. Knockdown by deltamethrin on both types of surfaces resulted in 100% final mortality. A lower insecticidal effect was observed on mud walls. However, three months after treatment, sprayed lime-coated mud surfaces displayed a twofold greater capacity (57.5%) to kill triatomines than mud sprayed surfaces (25%). Re-infestation was detected by manual capture only in one locality, six months after spraying,

We investigated the residual efficacy of four insecticide formulations used in Chagas disease vector control campaigns: cyfluthrin 12.5% suspension concentrace (SC), lambda-cyhalothrin 10% wettable powder (WP), deltamethrin 2.5% SC, and 2.5% WP on four types of circular blocks of wood, straw with mud, straw with mud painted with lime, and mud containing 5% of cement. Three concentrations of these insecticides were tested: the LC90 (previously determined on filter paper), the double of the LC90, and the recommended operational dose. For each bioassay test, 15 third-stage nymphs of Triatoma infestans (Klug) (Hemiptera: Reduviidae) were exposed for 120 h to each treatment at 24 h, 30, 60, 90, and 180 days post-spraying. Mortality rates, moulting history and behaviour were recorded at 24, 48, 72, and 120 h of exposure. Mortality rates were highest during the first 30 days post-spraying. Highest mortality rates (above 50%) were observed for deltamethrin 2.5% SC and lambda-cyhalothrin 10% WP on wood blocks up to three months post-spraying. Mud was the substrate on which treatments showed lowest persistence, with the other two substrates showing intermediate residual efficacy of all treatments. During the first 30 days WP formulations were not as effective as SC flowable formulations but, overall in the longer term, WP gave grater mortality rates of T. infestans nymphs exposed at up to six months post-spraying. Porous surfaces, especially mud, showed most variability presumably due to absorption of the insecticide. In contrast the less porous surfaces (i.e. wood and lime-coated mud) kept mortality rates high for longer post-treatment, irrespective of the insecticide concentration used.