Abstract The effects of heat treatment on the microstructural evolution and mechanical behavior of Al-Si-Cu alloy were investigated. Solution heat treatment was performed at 500oC/6h and 540oC/6h, followed by quenching in warm water at 60ºC. Lastly, artificial ageing treatment was performed at 160ºC/6h, 190ºC/4h and 210ºC/2h. The microstructural evolution of the samples before and after heat treatments was analyzed by optical microscopy, scanning electronic microscopy (SEM) and Energy Dispersive Spectroscopy (EDS). Analyses revealed the presence Al5FeSi, Al15(FeMn)3Si2, Al2Cu and Si particles. The morphologies of the present phases were dependent on the heat treatment. Solution treatment at 540ºC/6h resulted in significant softening of the alloy compared with the treated samples at 500ºC/6h. Vickers hardness analysis indicated that the hardness peak of the alloy after heat treatment was about 125 HV. Mechanical properties of different phases have been investigated by nanoindentation technique, which indicated that the highest hardness and modulus of elasticity were found for the Si particle, especially those distributed in the microstructures of the samples submitted to higher solution and ageing temperatures.

AbstractIn this paper, chrome (Cr) thin films were deposited and used as interlayer between SiC films and Ti-6Al-4V substrates. Films and interlayers were obtained by using HiPIMS (High Power Impulse Magnetron Sputtering) technique. Interlayers were growth for 5, 30, and 60 minutes. The films were analyzed with respect to morphology, stoichiometry, thickness, roughness, and adhesion. The results showed that the HiPIMS technique was efficient to produce dense thin films and that the adhesion increased with Cr thickness.