SUMMARY: This study aimed to investigate the sagittal spinal-pelvic morphological changes, as well as the relationship between pelvic anatomical changes and the spinal-pelvic plane in patients with adolescent idiopathic scoliosis (AIS), in order to provide guidelines for orthopedic surgery in AIS. X-ray data were collected for retrospective analysis from 30 patients diagnosed as AIS in the Departments of Radiology at the Second Affiliated Hospital of Inner Mongolia Medical University and the Inner Mongolia International Mongolian Medical Hospital from April 2014 to November 2018, along with 30 normal adolescents as control. Pelvic parameters, including pelvic incidence (PI), pelvic tilt (PT), and sacral slope (SS), a spinal parameter, lumbar lordosis (LL), and anatomical parameters, including sacral width (SW) and femoral head- sacrum distance (FH-S), were measured. The spinal-pelvic parameters were compared between AIS patients and normal controls and also between male and female AIS patients. Pearson correlation was performed to analyze correlation between spinal-pelvic parameters and between spinal-pelvic parameters and anatomical parameters in both AIS patients and normal controls. PT was significantly lower in AIS patients than in normal controls (P < 0.05), whereas no significant difference was found in the other spinal-pelvic parameters, i. e. , LL, PI, and SS. There was a significant difference in PT between sexes in AIS patients. SS was significantly correlated with LL in EIA patients (P < 0.05, r > 0.5). SS was significantly correlated with LL and PI, and PT with LL, PI, and SS in normal controls (all P < 0.05), and there was no significant correlation between the other sagittal spinal-pelvic parameters (P > 0.05). FH-S was significantly correlated with LL, PI, SS, and PT in AIS patients (all P < 0.05). AIS affects some of the sagittal spinalpelvic parameters and anatomical parameters. In AIS, there is a significant correlation between the spinal-pelvic parameters, and the anatomical parameter is significantly correlated with multiple spinal-pelvic parameters.

RESUMEN: Este estudio tuvo como objetivo investigar los cambios morfológicos sagitales de la columna vertebral-pélvica, así como la relación entre los cambios anatómicos pélvicos y el plano espinal-pélvico en pacientes con escoliosis idiopática adolescente (EIA), con el fin de proporcionar pautas para la cirugía ortopédica en AIS. Se obtuvieron los datos de rayos X para el análisis retrospectivo de 30 pacientes diagnosticados como EIA en los Departamentos de Radiología del hospital Second Affiliated Hospital of Inner Mongolia Medical University y el hospital Inner Mongolia International Mongolian Medical Hospital, desde abril de 2014 hasta noviembre del 2018, junto con 30 adolescentes normales como control. Se midieron los parámetros pélvicos, que incluyeron incidencia pélvica (IP), inclinación pélvica (P) y pendiente sacra (PS), un parámetro espinal, lordosis lumbar (LL) y parámetros anatómicos, que incluyeron el ancho sacro (AS) y la distancia del sacro cabeza femoral (FH-S). Los parámetros espinalpélvicos se compararon entre los pacientes con EIA y los controles normales, como también entre pacientes con EIA masculinos y femeninos. La correlación de Pearson se realizó para analizar la correlación entre los parámetros espinal-pélvicos y entre los parámetros espinal-pélvicos y los parámetros anatómicos tanto en pacientes con EIA como en controles normales. PT fue significativamente menor en pacientes con EIA que en los controles normales (P <0,05), mientras que no se encontraron diferencias significativas en los otros parámetros espinal-pélvicos, i. mi. , LL, PI y SS. Hubo una diferencia significativa en PT en pacientes de ambos sexos con EIA. SS se correlacionó significativamente con LL en pacientes con EIA (P <0,05, r> 0,5). SS se correlacionó significativamente con LL y PI, y PT con LL, PI y SS en controles normales (todos P <0,05), y no hubo correlación significativa entre los otros parámetros sagitales de la columna vertebral-pélvica (P> 0,05) FH-S se correlacionó significativamente con LL, PI, SS y PT en pacientes con EIA (todos P <0,05). EIA afecta algunos de los parámetros sagitales de la columna vertebral-pélvica y los parámetros anatómicos. En EIA, existe una correlación significativa entre los parámetros espinal-pélvicos, y el parámetro anatómico se correlaciona significativamente con múltiples parámetros espinales-pélvicos.

Resumo Fundamentos: O modelo de hipertrofia cardíaca (HC) para ratos foi amplamente utilizado, proporcionando assim uma base de pesquisa efetiva para a exploração de HC. Objetivo: pesquisar os efeitos do modelamento de HC sob constrição da aorta abdominal (CAA) usando diferentes agulhas e pesos em ratos. Métodos: foram utilizadas quatro agulhas com diâmetros externos diferentes (0,35, 0,40, 0,45 e 0,50 mm) para CAA. Foram selecionados 150 ratos C57BL / 6 machos de acordo com o peso corporal (PC) e divididos em 3 níveis de peso: 18 g, 22 g e 26g (n = 50 em cada grupo). Todos os níveis de peso foram divididos em 5 grupos: um grupo sham (n = 10) e 4 grupos CAA usando 4 intensidades de ligadura (n = 10 por grupo). Após a cirurgia, foram registradas as taxas de sobrevivência, foi realizada ecocardiografia, os corações foram dissecados e utilizados para detecção histológica, e os dados foram analisados estatisticamente, p < 0,05 foi considerado estatisticamente significante. Resultados: Todos os ratos morreram nos seguintes grupos de CAA: 18 g/0,35 mm, 22 g/0,35 mm, 26 g/0,35 mm, 22 g/0,40 mm e 26 g/0,40 mm. Todos os ratos com CAA, aqueles ligados com uma agulha de 0,50 mm, e aqueles que sofreram operação sham sobreviveram. Ocorreram diferentes taxas de mortalidade nos seguintes grupos de CAA: 18 g/0,40 mm, 18 g/0,45 mm, 18 g/0,50 mm, 22 g/45 mm, 22 g/0,50 mm, 26 g/0,45 mm e 26 g/0,50 mm. As proporções de peso do coração/peso corporal (5,39 ± 0,85, 6,41 ± 0,68, 4,67 ± 0,37, 5,22 ± 0,42, 4,23 ± 0,28, 5,41 ± 0,14 e 4,02 ± 0,13) aumentaram significativamente em comparação com os grupos sham para ratos com os mesmos níveis de peso. Conclusão: uma agulha de 0,45mm levou a HC mais óbvia do que as agulhas de 0,40 mm e 0,50mm e causou HC extraordinária em ratos de 18 g.

Abstract Background: The cardiac hypertrophy (CH) model for mice has been widely used, thereby providing an effective research foundation for CH exploration. Objective: To research the effects of CH modeling under abdominal aortic constriction (AAC) using different needles and weights in mice. Methods: Four needles with different external diameters (0.35, 0.40, 0.45, and 0.50 mm) were used for AAC. 150 male C57BL/6 mice were selected according to body weight (BW) and divided into 3 weight levels: 18 g, 22 g, and 26 g (n = 50 in each group). All weight levels were divided into 5 groups: a sham group (n = 10) and 4 AAC groups using 4 ligation intensities (n = 10 per group). After surgery, survival rates were recorded, echocardiography was performed, hearts were dissected and used for histological detection, and data were statistically analyzed, P < 0.05 was considered statistically significant. Results: All mice died in the following AAC groups: 18g/0.35 mm, 22 g/0.35 mm, 26 g/0.35 mm, 22 g/0.40 mm, and 26 g/0.40 mm. All mice with AAC, those ligated with a 0.50-mm needle, and those that underwent sham operation survived. Different death rates occurred in the following AAC groups: 18 g/0.40 mm, 18 g/0.45 mm, 18 g/0.50 mm, 22 g/45 mm, 22 g/0.50 mm, 26 g/0.45 mm, and 26 g/0.50 mm. The heart weight/body weight ratios (5.39 ± 0.85, 6.41 ± 0.68, 4.67 ± 0.37, 5.22 ± 0.42, 4.23 ± 0.28, 5.41 ± 0.14, and 4.02 ± 0.13) were significantly increased compared with those of the sham groups for mice with the same weight levels. Conclusion: A 0.45-mm needle led to more obvious CH than did 0.40-mm and 0.50-mm needles and caused extraordinary CH in 18-g mice.

Abstract The amylose content (AC) of rice is a key determinant of the grain cooking and eating quality. The Waxy (Wx) gene, which encodes granule-bound starch synthase I (GBSSI), is the major gene controlling AC in rice. The A - C substitution in exon 6 (Ex6A/C) alters the amino acid codon from serine to tyrosine and is associated with intermediate-AC rice (Wx-in). In this paper, we reported a perfect functional marker for the SNP Ex6A/C of Wx-in based on polymerase chain reaction with confronting two-pair primers (PCR-CTPP) in a single-tube PCR assay. Specificity and applicability of the PCR assay were verified in a Chinese mini core collection (MCC) of Oryza sativa L. and a breeding population. Were commend the use of the simple, inexpensive assay for routine genotyping for intermediate AC in the breeding population or discrimination of Wx-in genotypes in rice germplasm.

Um masterbatch (MA) reativo de poliamida 6 (PA6)/SiO2 contendo 20% (fração de massa) de nano-SiO2 foi preparado. Posteriormente, o MA reativo preparado foi usado como carga no preparo de nanocompósitos PA6/SiO2 (RA). A estrutura do RA foi analisada por espectrometria no infravermelho por transformada de Fourier (FTIR), microscopia eletrônica de transmissão (TEM), difratometria de raios X (XRD), microscopia eletrônica de varredura (SEM) e microscopia óptica de luz polarizada (POM). A estabilidade térmica e o comportamento de cristalização do RA foram avaliados por análise termogravimétrica (TGA) e calorimetria exploratória diferencial (DSC). OS resultados indicaram que as cadeias moleculares de PA6 estavam ancoradas na superfície do nano-SiO2 através de ligações químicas entre a superfície de grupos amino do nano-SiO2 e do monômero da ε-caprolactama ou pré-polímero da PA6. Como resultado, uma camada interfacial flexível foi formada, melhorando a compatibilidade do nano-SiO2 com a matriz de PA6. Além disso, o efeito no nano-SiO2 apresentou melhoras nas propriedades mecânicas do RA. Devido ao efeito de impedimento de movimento das cadeias moleculares da PA6 pelas partículas de nano-SiO2, o tamanho da esfera cristalina de PA6 foi menor e sua forma cristalina também foi afetada. A massa molar da matriz de PA6 tende a decair gradualmente com o aumento do conteúdo nano-SiO2.

A reactive polyamide 6 (PA6)/SiO2 masterbatch (MA) containing 20% (mass fraction) of nano-SiO2 was prepared readily. Furthermore, the as-prepared reactive MA was used as a filler to prepare PA6/SiO2 nanocomposites (RA). The structure of RA was analyzed by means of Fourier transform infrared spectrophotometry (FTIR), transmission electron microscopy (TEM), powder X-ray diffractometry (XRD), scanning electronic microscopy (SEM) and polarizing microscopy (POM). Thermal stability and crystallization behaviors of RA were evaluated by thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). Findings indicated that the PA6 molecular chains were anchored on the surface of nano-SiO2 through chemical bonding between the surface amino groups of nano-SiO2 and ε-caprolactam monomer or prepolymer of PA6. As a result, a flexible interfacial layer was formed, thereby improving the compatibility of nano-SiO2 with PA6 matrix. Moreover, the enhancement effect of nano-SiO2 led to the improved mechanical properties of RA. Besides, due to the hindering effect of nano-SiO2 particles to the movement of PA6 molecular chains, the size of the PA6 spherocrystal was smaller, and its crystalline form was also affected. Furthermore, the molecular weight of the PA6 matrix tended to decrease gradually with increasing nano-SiO2 content.

Lead-free ceramics Ba(Zr xTi1-x)O3 (x = 0.02-0.2) were prepared using a solid-state reaction technique. The structural and electrical properties were systemically investigated. Crystalline structures and microstructures were analyzed by X-ray diffraction and scanning electron microscope (SEM) at room temperature. All the samples possess pure perovskite structure. A small amount of Zr content has great effect on the microstructure of Ba(Zr xTi1-x)O3 ceramics. The homogeneous microstructure with grain size about 30µm is obtained for the sample at x = 0.05. The phase transitions merge together in one peak for the samples at x = 0.10 and the highest dielectric constant 15900 is obtained for the sample at x = 0.15. The Ba(Zr xTi1-x)O3 ceramics at x=0.05 exhibit excellent piezoelectric properties of high d33 = 208 pC/N, k p = 31.5% and Qm = 500.