In this work, iron ore tailing (IOT) was used for the production of two different materials: sodium silicate and geopolymers. Initially, reactions of IOT with NaOH were carried out by hydrothermal reaction in autoclave at 200 °C (1:1.5 and 1:2.5 SiO2:NaOH molar ratio) and reaction times of 4 and 8 h. X-ray fluorescence by dispersive energy (XRF), X-ray diffraction (XRD), Mössbauer spectroscopy, scanning electron microscopy (SEM-EDS) and titrations showed that IOT:NaOH ratios of 1:2.5 and reaction time 8 h completely dissolved the quartz from the IOT, obtaining a solid fraction consisting mainly of hematite and an aqueous phase of sodium silicate, which showed contents of ca. 23% SiO2 and 19% Na2O. This sodium silicate obtained was then combined with IOT (25 and 50 wt.%) to produce geopolimeric material with excellent physico-chemical properties, fast curing time and very good compressive strength results, which ranged from 41 to 58 MPa and many potential applications.

In this work, bio-oil (an organic matrix rich in oxygen functionalities) was used to efficiently dissolve and disperse Fe3+ which upon thermal treatment produced a carbon containing dispersed and encapsulated Fe oxide magnetic nanoparticles. These materials were prepared by dissolution of 8, 16 and 24 wt.% Fe3+ salt in bio-oil followed by treatment at 400, 450, 500 or 600 ºC in N2 atmosphere. X-ray diffraction (XRD), scanning (SEM) and transmission electron microscopies (TEM), elemental analysis, thermogravimetric-mass spectrometry (TG-MS), potentiometric titration, Raman and Mössbauer spectroscopies showed that Fe3+ species in bio-oil is reduced to produce magnetic nanoparticles phases: magnetite Fe3O4 and maghemite γ-Fe2O3. At low temperatures, the iron phases were less protected, and the carbon matrix was more reactive, while in temperatures above 500 ºC, the iron phases were more stable, however, the carbon matrix was less reactive. Reaction of these magnetic carbon materials with concentrated H2SO4 produced surface sulfonic acidic sites (ca. 1 mmol g-1), especially for the materials obtained at 400 and 450 ºC. The materials were used as catalysts on esterification reaction of oleic acid with methanol at 100 ºC and conversions of 90% were reached, however, after 2 consecutive uses, the conversion decreased to 30%, being required more studies to improve the material stability.

A magnetic catalyst (sample MCat) consisting of KI supported on a mixture of silica and maghemite (γ-Fe2O3) was prepared and used in the transesterification reaction for the synthesis of biodiesel. The energy dispersive X-ray spectrum of the catalyst showed signals due to Si, Fe, K, and I. Powder X-ray diffraction data revealed the amorphous nature of the SiO2 and the duly impregnation of the support with KI. 57Fe Mössbauer spectroscopy and magnetization measurements confirmed the ferrimagnetic iron oxide in the catalyst to be maghemite. N2 adsorption-desorption data indicated that the silica is mesoporous with a specific area of 352 m2 g-1, enabling the impregnation of 40 and 11 wt.% of KI and maghemite, respectively, according to the chemical composition obtained by the X-ray fluorescence measurements. The MCat was found to be efficient in the transesterification reaction in the macaúba and soybean oils. The MCat was easily removed from the reaction medium, with a hand magnet, and efficiently reused for more four consecutive reaction cycles. The good catalytic activity along with its magnetic behavior, high chemical stability and recyclability make the MCat a suitable material for the green synthesis of biodiesel.

Nd16Co72-xRu xC11B boro-carbides have been prepared by arc melting and studied by X-ray diffraction and magnetization measurements. X-ray diffraction results confirm that all the prepared alloys possess the tetragonal 2:14:1 (P4(2)/mmm) hard magnetic phase. The observed decrease of the magnetization and Curie temperature indicate the development of antiferromagnetic spin correlations with the increase of the Ru content. The combined addition of B and C is favorable to the formation and stabilization of the tetragonal phase in these compounds. At lower Ru contents the Curie temperature is higher than in the corresponding Co-based boride in spite of larger cell volumes.

The Nd16Co76-xRu xC7B system has been investigated to assess the effect of boron-carbon combined addition on the ferromagnetic behavior of these intermetallic compounds. The results indicate that the addition of 1 at.% B favors the formation of the tetragonal magnetic phase 2:14:1 in these alloys. With the increase of the Ru concentration is observed an expansion of the lattice in the basal plane as well as a contraction along the c direction of the tetragonal unit cell. The Curie temperature decreases from 432 K at x = 6 to 421 K for x = 27, whereas the saturation magnetization has a steep decrease. The highest T C value has been verified for the alloy with the largest c parameter, despite its a parameter is the smallest one. In comparison to isotypic borides and pure carbides, a loss of coercivity and remanence is observed.

We performed a Mössbauer spectroscopy study of the iron meteorite Soledade. This meteorite, which consists of a metallic matrix, is an octahedrite with polycrystalline troilite, cohenite, schreibersite and rhabdites as major constituents. A chemical analysis indicates 6.78 % Ni, 0.46% Co, besides traces of Cu, Cr, Ga, Ge, As, Sb, W, Re, Ir and Au. No traces of silicates have been found and no oxygen was detected. Iron is appearing in the austhenitic phase and alloyed with nickel. An analysis of the Mössbauer spectra at room temperature indicates that the Fe-Ni phase is homogeneously distributed in the matrix, although variations in the composition between different regions are observed.

As argilas encontradas em amostras de solos, provenientes de Terras Indígenas do planalto médio do Rio Grande do Sul, foram caracterizadas com o intuito de fornecer dados e parâmetros técnicos para seu uso como matéria prima de produtos cerâmicos. O estudo mineralógico efetuado nas amostras utilizando a técnica de difração de raios X demonstrou que o argilomineral predominante é a caulinita. Outros minerais, como quartzo e rutilo, encontram-se presentes em menor quantidade. As análises químicas demonstram que as quantidades de óxido de Mg, Mn, K, Na, Ca, Cu e Zn são baixas (a soma das porcentagens é menor que 0,97 %). As amostras foram analisadas por espectroscopia Mössbauer de 57Fe. Os espectros Mössbauer obtidos na temperatura ambiente confirmam a presença do mineral caulinita. Os espectros a 77 K revelam a existência dos minerais goetita e hematita, na forma de partículas magnéticas ultrafinas (nanopartículas) em estado superparamagnético. Os testes físicos efetuados nas amostras indicam que os solos são finos e apresentam características granulométricas e de plasticidade, que podem ser aproveitadas para a produção de materiais cerâmicos para construção ou objetos ornamentais.

Clay samples collected from soils of indian territories of the middle plateau in Rio Grande do Sul were analyzed with the aim to obtain characterization data and technical parameters for their potential use as raw material for ceramic products. The mineralogical study in samples by using the X-ray diffraction technique demonstrated that the predominant clay mineral is kaolinite. Others minerals as quartz and rutile also are present in small amounts. Chemical analysis shows low percentages for oxides of Mg, Mn, K, Na, Ca, Cu and Zn (overall percentages smaller than 0.97%). The samples also were analyzed with the 57Fe Mössbauer spectroscopy. The Mössbauer spectra at room temperature confirm the presence of the mineral kaolinite. At 77 K they reveal the existence of the minerals goethite and hematite as ultrafine magnetic particles in a superparamagnetic state. The physical tests performed in the samples show that these soils are very fine material and present appropriate granulometric characteristics and plasticity, which can be taken in advantage for the production of materials for construction or production of ornamental artifacts.