Desde el año 2010 y hasta el 2012 se realizó la evaluación de 23 tipos de emisores o goteros que se encuentran en el mercado colombiano y se les determinó: el coeficiente de variación (CV); la variación del caudal medio comparado con el caudal nominal; las dimensiones de los pasajes y de sus partes constitutivas; la sensibilidad a la presión; el tipo de material y la resistencia a la presión hidrostática. Las mediciones se realizaron en el laboratorio de riego a presión del Departamento de Ingeniería Civil e Ingeniería Agrícola de la Facultad de Ingeniería de la Universidad Nacional de Colombia, Bogotá, en condiciones de operación controladas de acuerdo con las normas de calidad ISO 9260, 1991 y UNE 68-075, 1986. De los emisores evaluados el 43,48% son categoría A, con CV menor a 5%, el 26,09% categoría B con CV entre 5% y 10% y el 30,43% categoría C, con CV mayor a 10%. El porcentaje de variación del caudal medio respecto al caudal nominal de los emisores analizados muestran que solo el 17,32% (4) corresponden a la categoría A, mientras que el 82,61% (19) restante a la categoría B. Cinco emisores tienen una altura de laberinto menor a 0,7 mm, diecisiete entre 0,7 y 1,5 mm y uno superior a 1,5 mm (que los hace: muy sensible, ligeramente sensible y muy resistente a taponamiento, respectivamente). Este trabajo muestra la importancia de las características del emisor en las instalaciones de riego y la incidencia sobre el ahorro de agua, consumo de energía y combustible y el incremento de la rentabilidad al reducir los costos de operación y aumentar la eficiencia de distribución del agua.
From 2010 to 2012, an assessment was carried out on twenty-three emitter or dripper types found in the Colombian market. The following were determined: the coefficient of variation (CV), the variation of the average flow rate compared to the nominal flow, the dimensions of the passages and the constituent parts, the pressure sensitivity, the type of material and the resistance to hydrostatic pressure. The measurements were taken in the laboratory of pressurized irrigation, Department of Civil Engineering and Agricultural Engineering, Faculty of Engineering, National University of Colombia, Bogotá with controlled operating conditions, according to the quality standards of ISO 9260, 1991 and UNE 68-075, 1986. Of the evaluated emitters, 43.48% were category A, with a CV less than 5%, 26.09% were category B, with a CV between 5 and 10%, and 30.43% were category C, with a CV greater than 10%. The percentage change in average flow rate with respect to the nominal flow of the evaluated emitters showed that only 17.32% (4) were category A, while 82.61% (19) were Class B. Five drippers had a labyrinth height lower than 0.7 mm, 17 between 0.7 and 1.5 mm and one above 1.5 mm (which correlate to very sensitive, slightly sensitive and highly resistant to clogging, respectively). This study shows the importance of emitters in irrigation facilities and the impact on water conservation, energy and fuel consumption and increased profitability from reducing operating costs and increasing the efficiency of water distribution.