Abstract In this paper, we present a spectral analysis of a Surface Plasmon Resonance (SPR) sensor based on multilayer graphene (MLG) operating as a terahertz refractometer. This device's structure is based on Kretschmann configuration, and the graphene layers are modeled as surface impedances with conductivity described by the Kubo model. The structure's electromagnetic response is obtained from the Generalized Coefficients Model, considering TM excitation performed in a frequency range from 1 to 4Thz. In this approach, we evaluate the sensor response for two, three, four and five layers of graphene, equally doped. To verify the effects of MLG doping, we varied the chemical potential by 0.35eV and 0.70eV. As a result, we present the plasmonic response of the device, verifying the operating frequency range for each case of multilayer graphene. In addition, the sensitivity, FWHM and Figure of Merit (FOM) are calculated to describe the sensor performance in each demonstrated case. From the results presented, we verified that the increase in doping reduces the sensitivity of the sensor, however, it improves its FOM. The validation of the proposed model was carried out from simulations in a software based on the Finite Element Method.

Abstract In this paper, we consider coupled disk-shaped resonators separated by a thin dielectric substrate that can be used as frequency-tunable filters or as electromagnetic switches in the terahertz frequency band. The two disks are electromagnetically coupled and resonate with dipole plasmonic modes. By using a Temporal Coupled-Mode Theory based approach, we show how to analytically calculate the frequency response of such structures.The analytical results are in good agreement with those obtained from computational simulations based on the finite element method.

Abstract Faraday and Kerr effects as well as the extraordinary optical transmission in a structure that combines magneto-optical and plasmonic properties are studied. The planar structure consists of four layers, namely, dielectric layer, metal strips, once again dieletric layer and magneto-optic one. The magneto-optical layer is magnetized by a DC magnetic field normal to it. Our numerical analysis shows that the Faraday and Kerr rotations in this structure can be increased by more than two times in comparison with the published results. This is achieved due to high Q-factor resonances in magneto-optic layer.

Abstract Partial discharge (PD) monitoring is widely used in rotating machines to evaluate the condition of stator winding insulation, but its practice on a large scale requires the development of intelligent systems that automatically process these measurement data. In this paper, it is proposed a methodology of automatic PD classification in hydro-generator stator windings using neural networks. The database is formed from online PD measurements in hydro-generators in a real setting. Noise filtering techniques are applied to these data. Then, based on the concept of image projection, novel features are extracted from the filtered samples. These features are used as inputs for training several neural networks. The best performance network, obtained using statistical procedures, presents a recognition rate of 98%.

Abstract It is shown that proper representation of transmitting and receiving antennas in indoor environments are decisive for accurate prediction of electromagnetic power transfer parameters using the standard 3D-FDTD method. With the standard Yee method, it is not always possible to precisely describe all the geometrical details of electrically small antennas. A new approach for description of the discone antenna in uniform 3D-FDTD lattice is presented. The calculations are validated by comparing FDTD results with the polyhedral beam-tracing method and experimental data.

Abstract A methodology based on spectral analysis for localization of multiple partial discharges in dielectric region of hydro-generator coils is proposed. This pinpointing of multiple discharges aims to provide means for performing diagnosis of insulating regions of the coil. A numerical model of the structure was developed by using the finite-difference time-domain method (FDTD-3D) to solve Maxwell’s equations. Transient voltage associated with partial discharges that occurs at different positions of the coil is calculated at specific point and its spectrum is used to perform the diagnosis. In 90% of simulations, accurate estimates of simultaneous discharges location were obtained. Physical phenomena allowing the development of the methodology are assessed numerically and experimentally. Finally, a localized artificial PD injection schema is proposed and used for validating our numerical results and physical analysis.

Abstract In order to measure electrical signals produced by partial discharges in hydrogenerators stator windings, capacitive couplers are regularly used. They are electrically connected to the windings and therefore, require undesired insulation intrusion. For avoiding such an intrusion, a microstrip directional coupler is used, which is experimentally and numerically investigated in this work. This electromagnetic field sensor is analyzed initially via computer simulation using the finite-difference time-domain method. This numerical analysis is fulfilled considering the coupler placed over a stator bar. Experimental high-voltage tests with generator windings were also performed. We compare the results of the measurements obtained by using various sensors and show that the microstrip directional coupler has some important advantages over traditional capacitive sensors such as complete conductive insulation from the windings and the capacity of detecting shorter PD pulses due to their wider bandwidth.

ABSTRACT: Carbon nanotubes are possible building blocks in the development of new generation of electronic devices. The carbon nanotubes allow one fabrication of devices using nanometric scales. They can be used in projects of a wide range of electronic and optoelectronic components such as diodes, transistors and interconnection elements, among others. This paper presents the state-of-the-art of this area, emphasizing the influence of quantum effects on the characteristics of such components.

The pristine boron nitride nanotubes have a large direct band gap around 5 eV. This band gap can be engineered by doping. We investigate electronic structure of the doped hexagonal boron nitride (5,5) nanotubes using the linearized augmented cylindrical wave method. In particular, this work focuses on systematical study of the band gap and the density of states around the Fermi-level when the nanotubes are doped by intrinsic impurities of two substitutional boron atoms in a super cell and a comparative analysis of the relative stability of three structures studied here. This corresponds to 3.3% of impurity concentration. We calculate 29 configurations of the nanotubes with different positions of the intrinsic impurities in the nanotube. The band gap and density of states around the Fermi level show strong dependence on the relative positions of the impurity atoms. The two defect sub bands called Dπ(B) appear in the band gap of the pristine nanotube. The doped nanotubes possess p-type semiconductor properties with the band gap of 1.3-1.9 eV.

In this paper, we present an algorithm for full-wave electromagnetic analysis of nanoplasmonic structures. We use the three-dimensional Method of Moments to solve the electric field integral equation. The computational algorithm is developed in the language C. As examples of application of the code, the problems of scattering from a nanosphere and a rectangular nanorod are analyzed. The calculated characteristics are the near field distribution and the spectral response of these nanoparticles. The convergence of the method for different discretization sizes is also discussed.

In this paper, we present an analysis of the resonant response of modified triangular metallic nanoparticles with polynomial sides. The particles are illuminated by an incident plane wave and the method of moments is used to solve numerically the electromagnetic scattering problem. We investigate spectral response and near field distribution in function of the length and polynomial order of the nanoparticles. Our results show that in the analyzed wavelength range (0.5-1.8) µm these particles possess smaller number of resonances and their resonant wavelengths, near field enhancement and field confinement are higher than those of the conventional triangular particle with linear sides.

We present a microwave switchable frequency selective surface with high quality factor transmission resonance. The high quality resonance is achieved by excitation of the trapped-mode in array with two concentric metal rings in a cell on a silicon substrate. Optical activation of the silicon substrate permits to switch off the transmission band.

In this work, we analyze modified bowtie nanoantennas with polynomial sides in the excitation and emission regimes. In the excitation regime, the antennas are illuminated by an incident plane wave, and in the emission regime, the excitation is fulfilled by infinitesimal electric dipole positioned in the gap of the nanoantennas. Several antennas with different sizes and polynomial order were numerically analyzed by method of moments. The results show that these novel antennas possess a controllable resonance by the polynomial order and good characteristics of near field enhancement and confinement for applications in enhancement of spontaneous emission of a single molecule.

In this paper, we present a quantitative comparison of circular and triangular gold nanodisks with the same length and thickness. The method of moments is used to solve numerically the scattering problem. With this model, we investigate the spatial near field distribution, spectral response, far field diagrams, and bandwidth wavelength of these particles. Our results show that the resonant wavelength and the near field enhancement and confinement of the triangular particle are larger than those for the circular particle, but the resonance bandwidth and scattering cross section of the triangular particle are smaller.