OBJECTIVE: There are no doubts about the clinical benefits of treatment with GnRH analogs for patients diagnosed with central precocious puberty (CPP). However, laboratory monitoring of CPP is still a matter of considerable controversy in the literature. Therefore, the main objective of this study was to evaluate the cut-off values of stimulated LH that determine gonadotrophic suppression. METHODS: Twenty-four girls, on treatment with leuprorelin acetate (LA) at 3.75 mg IM every 28 days, were studied. The clinical parameters used to indicate clinical effectiveness were regression or maintenance of sexual characteristics according to the Tanner stage, growth velocity reduction, reduction or maintenance of the difference between bone age and chronological age and maintenance or improvement of the final height prediction. For the laboratory effectiveness test, basal estradiol, LH, and FSH levels were collected before and 1 and 2 h after the administration of 3.75 mg LA. RESULTS: Eleven girls showed improvement in all clinical parameters, and their effectiveness tests were compared to those of the other patients to calculate the cut-off values, which were ≤3.64 IU/L (p=0.004*) for LH after 1 h and ≤6.10 IU/L (p<0.001*) for LH after 2 h. CONCLUSION: The LH response after the LA stimulation test, associated with clinical data and within a context of CPP, constitutes a reliable and feasible resource and can assist in monitoring the effectiveness of treatment.

The aim of this study was to evaluate the viability of bull spermatozoa collected from the cauda epididymis stored at 18-20°C, which were compared with semen collected by electro-ejaculation method and preserved at 5°C. Ten pairs of testes from Tabapuã bulls were removed by orchiectomy and stored for 6 (G6), 12 (G12), 18 (G18), 24 (G24) and 30 (G30) h at room temperature (18-20°C). Seven days before orchiectomy, semen was collected by electro-ejaculation method. The sperm parameters evaluated were: sperm motility, vigor, concentration, morphology and acrosome defects. Sperm motility declined (p<0.05) when spermatozoa were stored for 30 h in the epididymis. The spermatozoa from the epididymis showed lower sperm motility than that of spermatozoa collected via electro-ejaculation. There was a little expressive decrease in sperm vigor and increased in morphological defects with storage time, but the acrosome integrity was not affected. Cold storage (5°C) maintained sperm viable for 15 to 40.8 h. Thus, it was possible to recover viable sperm with 41.25% of motility from the cauda epididymis stored at room temperature of 18-20°C for 30 h. There were differences between the ejaculated and epididymal sperm for the bulls and the conservation at 5°C allowed short-term preservation of the gametes.

Objectives: To advance in the knowledge of Peruvian populations’ origin in a phylogeographical context. Design: Population genetics study. Setting: Human Genetics Laboratory, Biological Sciences Faculty, Universidad Nacional Mayor de San Marcos, and Genetics and Molecular Biology Institute, Faculty of Medicine, Universidad San Martin de Porras, Lima, Peru. Participants: Seven Peruvian populations. Methods: Comparative analysis of mtDNA and MBL nuclear gene study results in seven Peruvian populations processed separately and then combined using PHYLYP 3.65 Program in order to obtain FST values of genetic differentiation; construction of distance trees by applying UPGMA algorithm and subsequent generated clusters’ analysis. Main outcome measures: Genetic trees. Results: Trees generated for each genetic marker had proper and distinct topologies among them. Combined processing resulted in a tree with higher values of genetic differentiation in Lago Titicaca Islands (Puno, Peru) Taquile, Amantani y Anapia, graded as very high because they showed 0.3113, 0.2949 y 0.3348 FST values with respect to the populations studied outside of Puno Department -like Chachapoyas, Pucallpa and Chiclayo-, as well as those of both Uro’s in same Puno and Lago Titicaca’s populations (0.2837). Out of Puno, the pair Chachapoyas-Pucallpa population was the least divergent with 0.0108 FST value between them, classifying as small. Conclusions: The tree obtained from markers by a combined matrix process determined that populations inhabiting in Taquile, Amantani y Anapia islands possess notable genetic divergence respect to the four remainders studied in Peru, including the Uro’s population geographically very close to them and within the same Lago Titicaca. Our next objective will be to explain these findings initially by increasing genetic markers and number of populations analyzed in Peru.

Objetivos: Avanzar en el conocimiento del origen de las poblaciones peruanas estudiadas en un contexto filogeográfico. Diseño: Estudio genético poblacional. Instituciones: Laboratorio de Genética Humana, Facultad de Ciencias Biológicas, Universidad Nacional Mayor de San Marcos, e Instituto de Genética y Biología Molecular, Facultad de Medicina, Universidad San Martín de Porras, Lima, Perú. Participantes: Siete poblaciones peruanas. Metodología: Análisis comparativo de los resultados a partir del estudio del mtDNA y el gen nuclear MBL de siete poblaciones peruanas, procesados de manera separada y luego combinados, utilizando el programa PHYLYP 3.65, para obtener valores FST de diferenciación genética y la construcción de árboles de distancias por aplicación del algorritmo UPGMA y el análisis subsecuente de los agrupamientos (clusters) generados. Principales medidas de resultados: Árboles genéticos generados. Resultados: De manera separada, los árboles generados para cada marcador genético tuvieron topologías propias y diferentes entre sí. Procesados de manera combinada, el árbol resultante demostró que los mayores valores de diferenciación genética se hallaron en las Islas del Lago Titicaca (Puno, Perú) conocidas -Taquile, Amantani y Anapia-, que fue calificada como muy alta, porque mostró valores de FST de 0.3113, 0.2949 y 0.3348 respecto de las poblaciones estudiadas, tanto fuera del Departamento de Puno -como Chachapoyas, Pucallpa y Chiclayo, respectivamente-, así como a la de los Uro del mismo Puno y del mismo Lago Titicaca (0.2837). Fuera de Puno, el par de poblaciones Chachapoyas-Pucallpa fue el menos divergente, al alcanzar entre ellas un valor de FST de 0.0108, calificándosele de pequeña. Conclusiones: El árbol obtenido del procesamiento de los marcadores vía una matriz combinada demostró que las poblaciones que habitan las islas de Taquile, Amantani y Anapia, divergen notablemente de las restantes cuatro procesadas del Perú, incluyendo la más próxima a ellas dentro del mismo Lago Titicaca, como es la de los Uro. Explicar estos hallazgos será el siguiente objetivo de nuestras investigaciones, en principio, mediante la ampliación de los marcadores genéticos empleados y del número de poblaciones analizadas a nivel del Perú.

Uma das principais limitações relacionadas ao processo de retificação de cerâmica é a confiabilidade do material devido aos defeitos introduzidos no processamento. A compreensão dos mecanismos envolvidos na remoção de material durante a retificação e a interação com os parâmetros de processo e microestrutura é fundamental para minimizar estes defeitos. A proposta desta revisão é apresentar os modelos de remoção de material e a forma como afetam as propriedades mecânicas da peça final.

One of the major restrictions in grinding of ceramics is the probability of failure of material due to the damage induced during the process. The understanding of mechanisms of material removal on grinding and the interaction with the process parameters and microstructure is fundamental to minimize these problems. The purpose of this review is to present the models of material removal in ceramics and the way they affect the mechanical properties of the product.

The possibility of reusing excess sludge treated by hydrothermal reaction for the purpose of improving the efficiency of the enhanced biological phosphate removal (EBPR) process was investigated. Excess sludge from a fish-processing industry located in Japan was treated in high-temperature and high-pressure water, at a reaction temperature ranging from 200 to 400ºC, a pressure of 1.8 to 30MPa and a constant reaction time of 7 min. For the conditions tested, the results showed that when the reaction temperature was increased the content of readily biodegradable substrate in the total COD Cr increased. In addition, the amount of some volatile fatty acids (VFAs) produced by the hydrothermal reaction increased as reaction temperature increased. From the phosphate release tests under anaerobic conditions, it was possible to demonstrate that not only the VFAs, but also the readily and slowly biodegradable substrates are used as potential carbon source by the phosphate-accumulating organisms (PAOs).

Foi utilizado o método enzimático recomendado pela AOAC para determinação de beta-glucanas em cereais e alimentos que os contém. O método, utiliza liquenase (EC 3.2.1.73) e beta-glucosidase (EC 3.2.1.21) para hidrólise debeta-glucanas, é rápido, fácil de executar e específico para beta-glucanas com ligações beta(1->3) e beta(1->4). As sementes analisadas foram subministradas pelo Instituto Agronômico de Campinas (IAC) e os alimentos adquiridos nos supermercados. Aveia e cevada são os grãos com maior conteúdo de beta-glucanas. Na aveia os teores determinados foram 6,48 e 5,94%. Nos 10 cultivares de cevada os teores de beta-glucanas oscilaram entre 2,04 e 9,68%. Trigo e triticale apresentaram teores de b-glucanas menores que 1%. Nos produtos comerciais o teor de beta-glucanas estava relacionado ao tipo de cereal da fórmula. O produto comercial de maior conteúdo de beta-glucanas é o farelo de aveia. As beta-glucanas são ingredientes funcionais em potencial e a conveniência ou não de estimular sua incorporação em alimentos deve ser mais estudada. Quanto à composição centesimal dos grãos de cereais, o teor de proteínas foi o que apresentou a maior variação e isso se reflete na composição dos produtos comerciais.

The method employed was the enzymatic one recommended by de AOAC for the determination of beta-glucans in cereals and in foodstuffs containing cereals in their formulation. The method, using lichenase (EC 3.2.1.73) and beta-glucosidase (EC 3.2.1.21) for the hydrolysis of beta-glucans, is quick and easy to execute, but is specific for beta-glucans with beta(1->3) and beta(1->4) bonds. The Agronomic Institute of Campinas (IAC) supplied the seeds analyzed, and the foodstuffs were acquired in supermarkets. Oat and barley are the grains with the highest content of beta-glucans. In the oats, the determined values were 6.48 and 5.94%. In the 10 cultivars of barley, the content of beta-glucans varied between 2.04 and 9.68%. Wheat and triticale had beta-glucans contents lower than 1%. Commercial products had contents of beta-glucans according to the kind of cereal used in their formulas. The beta-glucans are potential functional ingredients, and the convenience or not, of stimulating their incorporation in foodstuffs must be further considered. The protein contents were the most important variation of cereals and that was reflected in foodstuffs too.