ABSTRACT: In addition to improving sustainability in cropping systems, the use of a spring and winter crop rotation system may be a viable option for mitigating soil CO2 emissions (ECO2). This study aimed to determine short-term ECO2 as affected by crop rotations and soil management over one soybean cycle in two no-till experiments, and to assess the soybean yields with the lowest ECO2. Two experiments were carried out in fall-winter as follows: i) triticale and sunflower were grown in Typic Rhodudalf (TR), and ii) ruzigrass, grain sorghum, and ruzigrass + grain sorghum were grown in Rhodic Hapludox (RH). In the spring, pearl millet, sunn hemp, and forage sorghum were grown in both experiments. In addition, in TR a fallow treatment was also applied in the spring. Soybean was grown every year in the summer, and ECO2 were recorded during the growing period. The average ECO2 was 0.58 and 0.84 g m2 h–1 with accumulated ECO2 of 5,268 and 7,813 kg ha–1 C-CO2 in TR and RH, respectively. Sunn hemp, when compared to pearl millet, resulted in lower ECO2 by up to 12 % and an increase in soybean yield of 9% in TR. In RH, under the winter crop Ruzigrazz+Sorghum, ECO2 were lower by 17%, although with the same soybean yield. Soil moisture and N content of crop residues are the main drivers of ECO2 and soil clay content seems to play an important role in ECO2 that is worthy of further studies. In conclusion, sunn hemp in crop rotation may be utilized to mitigate ECO2 and improve soybean yield.

ABSTRACT The harvesting system of green sugarcane, characterized by mechanized harvesting and no crop burning, affects soil quality by increasing the remaining straw left on the soil surface after harvesting, thus, contributing to the improvement of physical, chemical, and microbiological soil attributes, influencing CO2 fluxes. This study aimed to evaluate CO2 fluxes and their relation to soil properties in sugarcane crops under different harvesting managements: burned (B), Green harvesting for 5 years (G-5) and Green harvesting for ten years (G-10). For this, a 1 ha sampling grid with 30 points was installed in each area, all located in the Northeast of São Paulo State, Brazil. In each point, CO2 fluxes were measured and the soil was sampled to analyze the microbial biomass, physical (soil moisture and temperature, mean weight diameter, bulk density, clay, macroporosity and microporosity) and chemical characterization (pH, organic C, base saturation and P). The CO2 fluxes were divided into four quantitative criteria: high, moderate, low and very low from the Statistical Division (mean, first quartile, median and third quartile) and the other data were classified according this criterion. The Principal Component Analysis (PCA) was used to identify the main soil attributes that influence CO2 fluxes. The results showed that G-10 CO2 fluxes were 28 and 41 % higher than those in the G-5 and B treatments, respectively. The PCA analysis showed that macroporosity was the main soil attribute that influenced the high CO2 fluxes.

Na agricultura, a obtenção de maiores produtividades das culturas com base no manejo sustentável do solo tem levado a uma busca gradativa do conhecimento das variáveis envolvidas nos sistemas de produção. Determinar as causas da variabilidade dos atributos passa a ser uma etapa do planejamento estratégico no setor sucroenergético. Este trabalho teve por objetivo estudar a variabilidade espacial dos óxidos de ferro da fração argila e sua relação com atributos físicos e químicos do solo, em diferentes sistemas de colheita de cana-de-açúcar na Região de Ribeirão Preto, SP. Duas parcelas de 1 ha foram delimitadas em áreas com sistema de colheitas mecanizada e manual. Foram retiradas, em cada área, amostras de solos em 126 pontos, na profundidade de 0,00-0,25 m. Os resultados das análises mineralógicas e químicas foram submetidos às análises geoestatísticas, obtendo-se a dependência espacial, os semivariogramas e os mapas de krigagem dos atributos estudados. Para analisar a correlação espacial entre os atributos estudados, foram construídos semivariogramas cruzados. A variabilidade espacial dos atributos químicos é maior em áreas com colheita de cana crua, quando comparada com áreas de colheita de cana queimada, ao contrário dos atributos mineralógicos, que apresentaram os maiores alcances na área de cana crua. Os atributos matéria orgânica, diâmetro médio do cristal da goethita apresentaram correlação espacial negativa, enquanto a argila apresentou correlação positiva com a adsorção de fósforo nos dois sistemas de colheita de cana-de-açúcar avaliados.

In agriculture, the search for higher crop yields based on sustainable soil management has led to a gradual pursuit of knowledge of the variables related to production systems. The identification of the causes of variability of these properties has become a part of strategic planning in the sugar and ethanol industry. This study investigated the spatial variability of iron oxides in the clay fraction and its relationship to soil physical and chemical properties in different sugarcane cultivation systems in the region of Ribeirão Preto, São Paulo State. Two 1-ha plots were outlined in areas with mechanical and manual harvesting systems. Soil samples were taken at 126 points from the 0.00-0.25 m layer in both areas. The mineralogical and chemical data were subjected to geostatistical analyses, to determine the spatial dependence, semivariograms and kriging maps of the properties. To analyze the correlation between the parameters cross-semivariograms were constructed. The spatial variability of chemical properties was greater in areas with mechanical harvesting than burnt harvesting (manual harvesting), whereas the range of the mineralogical properties was largest in the area of green-harvested sugarcane. The properties organic matter, mean crystal diameter goethite had a negatively spatial correlation, while clay was positive correlated with P sorption in the two sugarcane harvest systems.

Appropriate management of agricultural crop residues could result in increases on soil organic carbon (SOC) and help to mitigate gas effect. To distinguish the contributions of SOC and sugarcane (Saccharum spp.) residues to the short-term CO2-C loss, we studied the influence of several tillage systems: heavy offset disk harrow (HO), chisel plow (CP), rotary tiller (RT), and sugarcane mill tiller (SM) in 2008, and CP, RT, SM, moldboard (MP), and subsoiler (SUB) in 2009, with and without sugarcane residues relative to no-till (NT) in the sugarcane producing region of Brazil. Soil CO2-C emissions were measured daily for two weeks after tillage using portable soil respiration systems. Daily CO2-C emissions declined after tillage regardless of tillage system. In 2008, total CO2-C from SOC and/or residue decomposition was greater for RT and lowest for CP. In 2009, emission was greatest for MP and CP with residues, and smallest for NT. SOC and residue contributed 47 % and 41 %, respectively, to total CO2-C emissions. Regarding the estimated emissions from sugarcane residue and SOC decomposition within the measurement period, CO2-C factor was similar to sugarcane residue and soil organic carbon decomposition, depending on the tillage system applied. Our approach may define new emission factors that are associated to tillage operations on bare or sugarcane-residue-covered soils to estimate the total carbon loss.

Para entendimento do impacto do preparo do solo sobre as emissões de CO2 desenvolvemos e aplicamos dois modelos conceituais que são capazes de prever a emissão de CO2 do solo após seu preparo em função da emissão da parcela sem distúrbio, acrescida de uma correção devido ao preparo. Os modelos assumem que o carbono presente na matéria orgânica lábil segue uma cinética de decaimento de primeira ordem, dada pela seguinte equação: dCsoil (t) / dt = -k Csoil (t), e que a emissão de C-CO2 é proporcional a taxa de decaimento do C no solo, onde Csolo(t) é a quantidade de carbono lábil disponível no tempo (t) e k é a constante de decaimento (tempo-1). Duas suposições foram testadas para determinação das emissões após o preparo do solo (Fp): a constante de decaimento do carbono lábil do solo (k) antes e após o preparo é igual (Modelo 1) ou desigual (Modelo 2). Conseqüentemente, a relação entre os fluxos de C das parcelas sem distúrbio (F SD) e onde o preparo do solo foi conduzido (F P) são dadas por: F P = F SD + a1 e-a2t (modelo 1) e F P = a3 F SD e-a4t (modelo 2), onde t é o tempo após o preparo. Fluxos de CO2 previstos e observados relevam um bom ajuste dos resultados com coeficiente de determinação (R²) tão alto quanto 0,91. O modelo 2 produz um ajuste ligeiramente superior quando comparado com o outro modelo. A velocidade das pás da enxada rotativa foi relacionada a um aumento na quantidade de carbono lábil e nas modificações do tempo de residência médio do carbono lábil do solo após preparo. A vantagem desta metodologia é que a variabilidade temporal das emissões induzidas pelo preparo do solo pode ser descrita a partir de uma função analítica simples, que inclui a emissão da parcela sem distúrbio e um termo exponencial modulado por parâmetros dependentes do preparo e de condições ambientais onde o experimento foi conduzido.

To further understand the impact of tillage on CO2 emission, the applicability of two conceptual models was tested, which describe the CO2 emission after tillage as a function of the non-tilled emission plus a correction due to the tillage disturbance. Models assume that C in readily decomposable organic matter follows a first-order reaction kinetics equation as: dCsoil (t) / dt = -k Csoil (t), and that soil C-CO2 emission is proportional to the C decay rate in soil, where Csoil(t) is the available labile soil C (g m-2) at any time (t) and k is the decay constant (time-1). Two possible assumptions were tested to determine the tilled (F T) fluxes: the decay constants (k) of labile soil C before and after tillage are different (Model 1) or not (Model 2). Accordingly, C flux relationships between non-tilled (F NT) and tilled (F T) conditions are given by: F T = F NT + a1 e-a2t (model 1) and F T = a3 F NT e-a4t (model 2), where t is time after tillage. Predicted and observed CO2 fluxes presented good agreement based on the coefficient of determination (R² = 0.91). Model comparison revealed a slightly improved statistical fit of model 2, where all C pools are assigned with the same k constant. Rotary speed was related to increases in the amount of labile C available and to changes of the mean resident labile C pool available after tillage. This approach allows describing the temporal variability of tillage-induced emissions by a simple analytical function, including non-tilled emission plus an exponential term modulated by tillage and environmentally dependent parameters.

A transmissão de radiação ultravioleta de comprimentos de onda entre 250 e 360 nm através do pelame e da epiderme de bovinos foi determinada em laboratório, usando-se amostras de couro de animais recém-abatidos. A quantidade de radiação transmitida através do pelame depende da coloração e também das características estruturais do pelame (espessura da capa; comprimento, diâmetro, número e inclinação dos pêlos), pelas quais é definido o trajeto médio de um fóton pela massa de pêlos (L). A maior transmissão é proporcionada por pelames brancos com altos valores de L, ao passo que pelames negros em geral apresentam transmissão nula ou muito baixa. Quanto menos pigmentada a epiderme, maior a transmissão de radiação através da sua superfície. A melhor proteção é proporcionada por pelames negros com baixo valor de L sobre epiderme igualmente negra, mas em vista do aquecimento causado pela absorção de radiação térmica (em vacas Holandesas a temperatura das malhas negras atinge 44,1ºC ao mesmo tempo em que a das malhas brancas é 37,7ºC), a combinação ideal para ambientes tropicais é um pelame branco com baixo valor de L sobre epiderme negra, uma combinação dificilmente encontrada em animais de raças européias. Uma alternativa seria um pelame negro com um baixo valor de L. Animais vermelhos apresentam alta transmissão de radiação UV através da epiderme e do pelame, sendo desaconselhados para ambientes tropicais. Entretanto, foi observada uma vaca Holandesa com áreas isoladas de epiderme negra coberta com pelame branco, o que pode trazer perspectivas para uma seleção para combinações mais adequadas de epiderme e pelame em bovinos de raças européias.

A laboratory study was carried on the transmission of ultraviolet radiation (UV, 250 to 360 nm wavelength) through the haircoat and the skin of cattle. Fresh samples of skin were measured under a solar simulator, taking account of the pigmentation of hair and skin and the structural characteristics of the haircoat (coat thickness, hair diameter, hair length, angle of the hairs to the skin surface, number of hairs per unit area), which defined the average free path length of a photon within the coat, L. White hairs with high L values showed the highest transmission coefficients, while black hairs presented in general very low or even nul transmission. The best protection against UV was given by black hairs with low L values over a black skin. However, because of the heating by absorption of thermal radiation (in a Holstein cow the temperature of the black spots reach 44.1ºC at the same time that of the white spots is 37.7ºC), the best choice for tropical environments will be a white coat with a low L value over a black skin. This is a combination hardly found in European cattle, however in the present study a Holstein cow was found with isolated areas of white hair over black skin. An alternative choice would be a black coat with a low L value. Red animals presented high UV transmission coefficients through both the coat and the skin, and are not good choices for tropical environments, unless they have also a high pigmented skin.