Cellulosic materials have several applications, from rheological modifiers to structural reinforcement and packaging components. Using cellulosic materials may also contribute to environmental sustainability because it can be sourced from agricultural byproducts. In this work, self-sustained composite films were produced by the casting of TEMPO-oxidized cellulose nanofibers/graphite composite dispersions. Oscillatory rheology and tensile strength tests showed that the presence of graphite did not significantly contribute to the enhancement of neither the rheological nor mechanical properties of the dispersions and films. Morphological analysis showed that particle segregation and setting occurred during film casting, resulting in particle concentration gradient along the thickness of the film. These results could indicate the low exfoliation efficiency of the microfluidization process and, therefore, justify why the graphite did not act as a reinforcement of the cellulose matrix. However, the graphite particles contributed to a higher barrier to water vapor permeation of the cellulosic films. applications components byproducts work selfsustained self sustained TEMPOoxidized TEMPO oxidized nanofibersgraphite nanofibers therefore matrix However

Objetivou-se, nesse trabalho, avaliar os briquetes dos resíduos do processamento dos grãos de café submetidos aos processos de carbonização e torrefação. Os briquetes foram carbonizados utilizando-se taxa de aquecimento de 1,67 ºC min-1 com temperatura inicial de 50 ºC e final de 450 ºC, por 30 min. A torrefação dos briquetes foi realizada em uma mufla em duas taxas de aquecimento: 1,5 e 3,0 ºC min-1 até 250 ºC, temperatura mantida durante 60 min. Foram determinados os rendimentos em briquetes torrificados e carbonizados, em líquido pirolenhoso, em gases não condensáveis e em carbono fixo. Para todos os briquetes foram quantificados os teores de carbono fixo, cinzas, voláteis, dos componentes elementares (C, H, N, S, O), o poder calorífico superior, a densidade aparente e energética e a resistência à compressão diametral. Os briquetes carbonizados apresentaram maior potencial energético devido aos elevados teores de carbono fixo e elementar e poder calorífico, porém baixa resistência mecânica. Os briquetes torrificados nas duas taxas de aquecimento consideradas apresentaram características e propriedades energéticas semelhantes mas densidade energética inferior em relação aos briquetes carbonizados e in natura.

This research aimed to evaluate the briquettes made with residues from processing of coffee grain submitted to carbonization and torrefaction. The briquettes were carbonized at a heating rate of 1.67 ºC min-1 with initial temperature of 50 ºC and final of 450 ºC, which was kept during 30 min. The torrefaction of the briquettes was made in a muffle furnace at two heating rates: 1.5 and 3.0 ºC min-1 until 250 ºC, temperature kept during 60 min. The yields in torrefied and carbonized briquettes, pyroligneous liquor, non-condensable gases and fixed carbon were determined. For all briquettes the fixed carbon, ash, volatile and elemental components (C, H, N, S, O) contents and higher heating value, apparent and energetic density and resistance to diametric compression were quantified. The carbonized briquette presented high energetic potential due to higher fixed and elemental carbon content and heating value, but had low mechanical resistance. The briquettes torrified at the two considered heating rates presented similar energetic properties and characteristics, but lower energetic density than carbonized and fresh briquettes.

Pb/Ti, Sn and Mg-based nanocomposite materials were prepared by the high-energy mechanical milling of commercial powders. The surface of these ceramic compounds was strongly influenced by the doping, diameter of the milling spheres and time of the mechanical milling (amorphization process). Such milling leads to the formation of nanocrystalline materials. The mechanical processing parameters of these compounds were investigated through Brunauer, Emmett and Teller isotherms, wide angle X-ray diffraction, transmission electron microscopy and CO2 adsorption.

Nickel nanoparticles supported on amorphous silica ceramic matrix were synthesized by the polymeric precursor method. The nanostructure was characterized by NMR, BET, XRD, SEM, TEM, and flame atomic absorption spectrometry techniques. It was observed a dependence of the crystallite size on the thermal annealing, under a N2 atmosphere. The materials presented a high catalytic activity and selectivity upon the beta-pinene hydrogenation reaction. The magnetic hystereses were also correlated with the morphology of the processed material.

No total, 42 pacientes foram submetidos a avaliação clínica, comportamental e neuropsicológica com o objetivo de eventual tratamento cirúrgico de epilepsia refratária aos tratamentos clínicos usuais. Monitorização de vídeo-EEG digital prolongado, avaliação do volume hipocampal por RM, lateralização de fala e memória pelo teste do Amobarbital (teste de Wada) foram utilizados. Dos 18 pacientes operados 12 foram submetidos a lobectomia temporal, com seguimento de 6-30 meses (média 17 meses), sendo que 8 encontram-se com melhora significativa do controle de crises, 2 com melhora parcial e em 2 não foi observada mudança substancial na intensidade e frequência de crises. Uma paciente foi submetida a lobectomia frontal direita com remissão total de crises. Cinco pacientes foram submetidos a calosotomia com graus variáveis de sucesso. Não houve mortalidade. A morbidade incluiu um hematoma subdural, uma hemiparesia transitória, um episódio de mania, uma pneumonia lobar e cefaléia tensional muscular frequente no pós-operatório imediato. Estes resultados preliminares indicam uma boa resposta do tratamento cirúrgico de epilepsia em um novo centro, com pacientes selecionados através de monitorização não invasiva.

A total of 42 patients were submitted to a clinical, behavioural and neuropsychological evaluation with the objective of eventual surgical treatment of epilepsy refractory to the usual clinical therapies. Prolonged video-EEG monitoring, MRI hippocampal volume measurement, lateralization of speech and memory using the amobarbital (Wada) test were used. Of 18 operated cases, 12 were submitted to temporal lobectomy, with a follow-up of 6-30 months; 8 patients had significant improvement in seizures control; 2 patients had partial improvement in seizure frequency and intensity; 2 patients had no improvement in seizure control. One patient underwent right frontal lobectomy with total remission of seizures and 5 had callosotomy with varying degrees of success. There was no mortality. Morbidity included one subdural hematoma, one transient hemiparesis, one episode of mania, one lobar pneumonia and frequent immediately post-operative muscular tension headaches. These early results indicate good results of temporal lobectomy patients investigated through a non-invasive presurgical evaluation.