Resumo em Inglês:
Abstract Dielectric properties of a material are of paramount importance in many areas of knowledge. All scientific fields that deal with the interaction of electromagnetic radiation with matter demand this information. Consequently, suitable methods for obtaining accurate dielectric data are required. In the microwave community, the dielectric metrology with the coaxial probe method is well known due to its simplicity and practicality. It is also pointed out as a broadband and wide temperature range technique. Despite this, a detailed study of the implications of thermal effects at calibration with this technique has not been plainly reported in the literature. In the present work, a concise exposition of the problem is made. Using air, short and water as standards, we have analyzed a set of calibration procedures with different thermal conditions and compared them with the isothermal case. With the aid of statistical analysis, we have made recommendations for precise and accurate dielectric measurements at high temperatures. Using glycerol as material under test (MUT) we also demonstrated that measurements at temperatures up to 50°C above the calibration temperature can provide reliable data. Thus, measurements of glycerol up to 140°C were performed by calibrating the system with water at 90°C. This important issue was raised due to the lack of standard material data in the literature for temperatures above 100°C. From the measured data we also have derived the Cole-Davidson model parameters of glycerol from 30 to 140°C.Resumo em Inglês:
Abstract Novel design of multi-band Crescent shape microstrip antenna is proposed. Modifications in equivalent circular patch yields new resonant modes nearer to the TM11 and TM21 modes in circular patch that gives four band frequency response showing dual polarizations. Proposed design gives 1 to 1.5% of bandwidth at each frequency with broadside radiation pattern. The resonance frequency equation by defining the resonant length at each mode in the Crescent shape patch, is proposed. The frequency calculated using the same agrees closely with simulated result. The air suspended design of crescent shape patch is presented which yields co-polar peak gain of above 1.5 dBi.Resumo em Inglês:
Abstract In this article, a dumbbell shaped microstrip broadband microstrip antenna with partial ground plane is presented, The overall dimension of the proposed antenna is 20 × 15 × 1.5 mm3 and is fabricated on FR4 substrate which has electrical permittivity of 4.3 and loss tangent of 0.025. FR4 is a low cost and easily available. The thickness of the substrate is 1.5 mm. The impedance bandwidth of the proposed antenna is 151.11 % (3.48 GHz to 25 GHz). The peak gain and radiation efficiency of the proposed antenna are 4.5 dB and 68 % respectively in the operating frequency band. Due to introduction of rings on the edges of the octagon and cutting of circular slots with the rectangular slits in the ground plane the antenna starts resonating from 3.48 GHz to 25 GHz. Simulated results are in good agreement with the measured results. The proposed antenna covers partial frequency range for ultra-wide band applications, 3.5/5.5 GHz WiMAX band, 5.2/5.8 GHz WLAN band, 8/12 GHz X-band, 12/18 GHz Ku -band. It can be used in space and satellite communications etc. Curves of radiation pattern and S-parameter of both simulated and measured results are shown. The impedance curves, surface current, radiation efficiency, simulated return losses, gain, and radiation patterns of the proposed antenna are described in the paper.Resumo em Inglês:
Abstract This paper focuses on amorphous silicon photo thin-film transistors with double layered insulator using Si3N4/Al2O3 or HfO2 as candidates for the succession of Si3N4 as a traditional insulator in the fabrication of hydrogenated amorphous silicon thin-film transistors. Whether for industry or for research, there is a need to investigate the use of thin gate insulators for these devices to overcome leakage current. Our investigations included direct and transfer characteristics in dark and under illumination, generated photocurrents, external quantum efficiency and responsivity. Performance is evaluated in terms of the dielectric thickness and nature. Improvements in the proposed structures regarding off-current, responsivity and quantum efficiency are achieved via these materials. Comparing with Si3N4/HfO2 transistor, the Si3N4/Al2O3 device shows the lowest off-current. The HfO2 device presents the highest on-current when illuminated. The generated photocurrent is higher for Si3N4/HfO2 transistor revealing a lower amount of trapped charge. Under illumination and for very thin thicknesses, both devices enhance the Si3N4 device off-current and reach Si3N4 single layer dielectric based phototransistor performance. external quantum efficiency and responsivity are higher in HfO2 devices comparing with Al2O3 devices. The results are promising and may support further investigations in order to develop high k gate insulators for MIS photo thin-film transistors.Resumo em Inglês:
Abstract This manuscript proposes a Filtenna operating in the frequency range of 5.15-5.35 GHz for possible application in wireless local area network (WLAN). Initially, a monopole antenna consisting of a square loop radiating patch is designed at 5.2 GHz and is integrated into a bandpass filter (BPF) with centre frequency of 5.2 GHz. Within the proposed frequency band of operation, the filtenna exhibits omni-directional radiation pattern, good selectivity and low reflection loss. Also, the VSWR observed is less than 2 and peak antenna gain is approximately 2.5 dBi within the frequency range. A consistency is obtained between the simulation and the experiment.Resumo em Inglês:
Abstract Photonic crystal fiber (PCF) structures with do-octagonal geometry have been studied. These do-octagonal PCF structure have smaller circular holes arranged in rhombic fashion at its centre. Moreover, these small holes are doped with materials like butanol, ethanol, methanol and propanol. Do-octagonal PCF structures doped with methanol and air filled structure report very high birefringence. Ultra flattened zero dispersion has been achieved by all the simulated structures. Besides, low confinement loss and large nonlinearity have also been reported. Numerical simulation for supercontinuum generation has been performed. Supercontinuum spectra obtained for peak power 1 kW, 2 kW, 5 kW and 10 kW are 650 nm, 950 nm, 1450 nm and 2050 nm respectively.Resumo em Inglês:
Abstract The two-dimensional ray tracing method allows an easy and fast modeling of tropospheric propagation in the microwave frequency range. A version of this method that determines ray trajectories, amplitudes and delays of the electromagnetic field, as well as the propagation loss in a two-dimensional inhomogeneous environment will be described. The implemented algorithm may consider generalized maps of modified refractivity (or refractive modulus), including not only the vertical gradients, but also their horizontal variations along the path between transmitter and receiver. Next, the present paper will discuss the results from the application of a model of evaporation duct height to data from instruments installed in sea buoys located along the Brazilian coast. Finally, the results from the application of the ray-tracing model to evaporation ducts will be presented, to analyze the propagation of microwave signals in the maritime environment. These results will also be compared with corresponding ones from the software Advanced Refractive Effects Prediction System 3.6, based on the numerical solution of a parabolic equation.Resumo em Inglês:
Abstract In this paper, we consider coupled disk-shaped resonators separated by a thin dielectric substrate that can be used as frequency-tunable filters or as electromagnetic switches in the terahertz frequency band. The two disks are electromagnetically coupled and resonate with dipole plasmonic modes. By using a Temporal Coupled-Mode Theory based approach, we show how to analytically calculate the frequency response of such structures.The analytical results are in good agreement with those obtained from computational simulations based on the finite element method.Resumo em Inglês:
Abstract This paper describes the application of the Firefly Algorithm for the optimization of linear and planar antenna arrays. In order to demonstrate the potential of this technique, three applications are reported. The first one is the synthesis of a radiation pattern with isoflux distribution with a non-uniformly spaced linear array composed of isotropic antennas. The second application is the optimization of a non-uniformly spaced planar array composed of isotropic radiators installed on an 8-U nanosatellite. Finally, the optimization of a 3×3 planar antenna array for beam steering with simultaneous side lobe level control is described, whereby the beamforming coefficients were allowed to assume only discrete values. In the three cases considered, good agreement between the desired (mask) and the optimized patterns has been obtained.