Acessibilidade / Reportar erro

Standardized precipitation index based on pearson type III distribution

Índice padronizado de precipitação baseado na distribuição pearson tipo III

The initial step in calculating the Standardized Precipitation Index (SPI) is to determine a probability density function (pdf) that describes the precipitation series under analysis. Once this pdf is determined, the cumulative probability of an observed precipitation amount is computed. The inverse normal function is then applied to the cumulative probability. The result is the SPI. This article assessed the changes in SPI final values, when computed based on Gamma 2-parameters (Gam) and Pearson Type III (PE3) distributions (SPIGam and SPIPE3, respectively). Monthly rainfall series, available from five weather stations of the State of São Paulo, were chosen for this study. Considering quantitative and qualitative assessments of goodness-of-fit (evaluated at 1-, 3-, and 6-months precipitation totals), the PE3 distribution seems to be a better choice than the Gam distribution, in describing the long-term rainfall series of the State of São Paulo. In addition, it was observed that the number of SPI time series that could be seen as normally distributed was higher when this drought index was computed from the PE3 distribution. Thus, the use of the Pearson type III distribution within the calculation algorithm of the SPI is recommended in the State of São Paulo.

drought; Gamma distribution; SPI


Sociedade Brasileira de Meteorologia Rua. Do México - Centro - Rio de Janeiro - RJ - Brasil, +55(83)981340757 - São Paulo - SP - Brazil
E-mail: sbmet@sbmet.org.br