SciELO - Scientific Electronic Library Online

 
vol.23 issue2Longitudinal clinical evaluation of post systems: a literature reviewCorrelation between maxillary central incisor crown morphology and mandibular dental arch form in normal occlusion subjects author indexsubject indexarticles search
Home Pagealphabetic serial listing  

Brazilian Dental Journal

Print version ISSN 0103-6440

Abstract

GALO, Rodrigo et al. Effects of chemical composition on the corrosion of dental alloys. Braz. Dent. J. [online]. 2012, vol.23, n.2, pp. 141-148. ISSN 0103-6440.  http://dx.doi.org/10.1590/S0103-64402012000200009.

The aim of this study was to determine the effect of the oral environment on the corrosion of dental alloys with different compositions, using electrochemical methods. The corrosion rates were obtained from the current-potential curves and electrochemical impedance spectroscopy (EIS). The effect of artificial saliva on the corrosion of dental alloys was dependent on alloy composition. Dissolution of the ions occurred in all tested dental alloys and the results were strongly dependent on the general alloy composition. Regarding the alloys containing nickel, the Ni-Cr and Ni-Cr-Ti alloys released 0.62 mg/L of Ni on average, while the Co-Cr dental alloy released ions between 0.01 and 0.03 mg/L of Co and Cr, respectively.The open-circuit potential stabilized at a higher level with lower deviation (standard deviation: Ni-Cr-6Ti = 32 mV/SCE and Co-Cr = 54 mV/SCE). The potenciodynamic curves of the dental alloys showed that the Ni-based dental alloy with >70 wt% of Ni had a similar curve and the Co-Cr dental alloy showed a low current density and hence a high resistance to corrosion compared with the Ni-based dental alloys. Some changes in microstructure were observed and this fact influenced the corrosion behavior for the alloys. The lower corrosion resistance also led to greater release of nickel ions to the medium. The quantity of Co ions released from the Co-Cr-Mo alloy was relatively small in the solutions. In addition, the quantity of Cr ions released into the artificial saliva from the Co-Cr alloy was lower than Cr release from the Ni-based dental alloys.

Keywords : Corrosion; metal ions; metal (alloys); surface characterization.

        · abstract in Portuguese     · text in English     · pdf in English