SciELO - Scientific Electronic Library Online

 
vol.13 número1Influência da temperatura, da massa molar e da distribuição de massa molar na tensão superficial de PS, PP e PE: experimento e teoriaDesenvolvimento de processo de reciclagem de resíduos industriais de poliuretano e caracterização dos produtos obtidos índice de autoresíndice de assuntospesquisa de artigos
Home Pagelista alfabética de periódicos  

Serviços Personalizados

Journal

Artigo

Indicadores

Links relacionados

Compartilhar


Polímeros

versão impressa ISSN 0104-1428versão On-line ISSN 1678-5169

Resumo

MOREIRA, Viviane X.  e  SOARES, Bluma G.. Evaluation of waste poly(ethylene-co-vinyl) incorporation in nitrile rubber. Polímeros [online]. 2003, vol.13, n.1, pp.54-63. ISSN 1678-5169.  https://doi.org/10.1590/S0104-14282003000100011.

The influence of poly(ethylene-co-vinyl acetate) (EVA) waste (EVAR) on the mechanical performance of NBR vulcanisates compounds was studied. The optimum concentration of EVAR, which has presented higher ultimate tensile stress, was found at 50 phr. In addition, the influence of EVA and EVAR functionalized with mercaptan groups (EVALSH) and EVAR functionalized with maleic anidride (EVARCO) as compatibilizing agents was studied. The copolymer EVALSH acted as accelerator for the curing system, since a decreasing of the curing time was observed. An improvement of ageing resistance was also observed. The addition of EVARCO resulted in a reduction of the curing time and an improvement of most of evaluated properties. The thermodynamic-mechanic properties were investigated by DMTA analysis. The studies on the interaction between dispersed phase and matrix were performed by scanning electron microscopy (SEM).

Palavras-chave : Elastomers compounds; EVA waste; mechanical properties; compatibilization.

        · resumo em Português     · texto em Português     · Português ( pdf )

 

Creative Commons License Todo o conteúdo deste periódico, exceto onde está identificado, está licenciado sob uma Licença Creative Commons