SciELO - Scientific Electronic Library Online

vol.57 número341Review article: rheology of high performance concretes applied in building siteSynthesis and characterization of layered double hydroxides from red mud índice de autoresíndice de materiabúsqueda de artículos
Home Pagelista alfabética de revistas  

Servicios Personalizados




Links relacionados



versión impresa ISSN 0366-6913


SOUSA, R. M. e et al. Grinding of alumina ceramics with different cooling and lubrification techniques: conventional and minimum quantity of lubrification. Cerâmica [online]. 2011, vol.57, n.341, pp.76-84. ISSN 0366-6913.

Nowadays, environmental concerns are causing companies to seek reduce the environmental impacts caused by them, while improving product quality and manufacturing processes. Therefore, much research is being developed in the machining area to examine the actual damage to the environment by utilizing different methods of lubrification and cooling. This study aimed to analyze the surface roughness of the machined part and the wear of the grinding wheel in the flat grinding of alumina ceramics with two methods of cooling-lubrification: The conventional method with a flow rate of 27.5 L/min and the method of the minimum quantity of lubrification (MQL) at 100 mL/h. With the obtained results it's possible to say that, for the same machining parameters of MQL and conventional techniques, the MQL technique used a much smaller amount of fluid and assured good results for the diametral wear of the grinding wheel. However, the superficial roughness of the piece was worse for the MQL method than the conventional cooling technique. These results showed that using alternative forms of lubrification to reduce the use of cutting fluid are possible, depending on which factors are most important to the process that is wanted. Accordingly, if the MQL technique was used, it would surely bring, on one hand, the benefits of the reduction of the problems of recycling and disposal the cutting fluid, but on the other hand, leads to a lower surface quality of the parts.

Palabras clave : ceramics; grinding; cutting fluid; MQL.

        · resumen en Portugués     · texto en Portugués     · Portugués ( pdf epdf )


Creative Commons License Todo el contenido de esta revista, excepto dónde está identificado, está bajo una Licencia Creative Commons