Acessibilidade / Reportar erro

Electrochemical behavior of two austenitic stainless steel biomaterials

Comportamento eletroquímico de dois aços inoxidáveis austeníticos utilizados como biomateriais

Potentiodynamic and potentiostatic polarization measurements were conducted in 0.9% NaCl solution to investigate the localized corrosion susceptibility of two austenitic stainless steel biomaterials: a low nitrogen, according to ASTM F 138 - the metallic material most widely utilized today in orthopedic applications; and a nitrogen- and niobium-bearing stainless steel, according to ISO 5832-9, which has shown a promising potential as a substitute of the F 138 steel for more severe loading applications and longer times inside the human body. The polarization tests revealed that the ISO 5832-9 steel is more corrosion resistant than the F 138. The critical pitting potential of the ISO 5832-9 steel could not be observed in the cyclic polarization curve up to the value of potential corresponding to its transpassivity. The potentiostatic scratch test confirmed the superiority of the ISO 5832-9 steel, which heal the mechanically damaged passive film at applied potential as high as 800 mV (SCE). Scanning electron microscopy (SEM) examination confirmed the presence of corrosion pits - lacelike pits - in a stable growth stage on the surface of F 138 steel and the absence of such pits in the specimens of the ISO 5832-9 steel. The higher corrosion resistance of the latter is attributed to the increased stability of the passive film and the high tendency to repassivate, which, in turn, is favored by the presence of nitrogen in interstitial solid solution in the austenite of this type of steel.

Austenitic stainless steel; localized corrosion; Z-phase; ISO 5832-9; metallic biomaterials; orthopedic implant


Escola de Minas Rua Carlos Walter Marinho Campos, 57 - Vila Itacolomy, 35400-000 Ouro Preto MG - Brazil, Tel: (55 31) 3551-4730/3559-7408 - Ouro Preto - MG - Brazil
E-mail: editor@rem.com.br