SciELO - Scientific Electronic Library Online

vol.25 número1Recurrent neural network approaches for biped walking robot based on zero-moment point criterionA model-based predictive control scheme for steal rolling mills using neural networks índice de autoresíndice de materiabúsqueda de artículos
Home Pagelista alfabética de revistas  

Servicios Personalizados




Links relacionados


Journal of the Brazilian Society of Mechanical Sciences and Engineering

versión impresa ISSN 1678-5878versión On-line ISSN 1806-3691


BIANCHI, E. C. et al. Transverse cylindrical grinding of a eutectic alloy. J. Braz. Soc. Mech. Sci. & Eng. [online]. 2003, vol.25, n.1, pp.79-84. ISSN 1678-5878.

We report herein on a comparison of the performance of two different grinding wheels (conventional and CBN) in the transverse cylindrical grinding of a eutectic alloy. Three cutting conditions were tested: rough, semi-finishing and finishing. The parameters of evaluation were the cutting force, roughness and wheel wear. The optimal cutting force and roughness values were obtained when grinding with the conventional wheel, due to the superior dressing operation performed under every cutting condition tested. Although the CBN wheel presented the best G ratio values, they were lower than expected owing to the inappropriate dressing operation applied. Excessive wheel corner wear was detected in both wheels, caused by the grinding kinematics (transverse grinding) employed. In terms of cutting force and roughness, the conventional wheel proved to be the better choice under the conditions tested. However, in terms of the G ratio, a cost analysis is crucial to determine whether the differences between the wheels justify the use of the CBN wheel, in which case the dressing operation requires improvement.

Palabras clave : Grinding; grinding wheel; performance; dressing.

        · texto en Inglés


Creative Commons License Todo el contenido de esta revista, excepto dónde está identificado, está bajo una Licencia Creative Commons