The purpose of this in vitro study was to compare the marginal leakage in primary molars restored with 2 polyacid-modified composite resins (Dyract AP - Dentsply and F2000 - 3M) and a composite resin (Filtek Z250 - 3M) as control. First and second primary molars were used for preparation of cavities on the proximal surfaces, with extension of the gingival margin to the cementoenamel junction. Restorations were accomplished after total etching and application of the respective adhesive system, and were divided into groups according to the restorative system and the number of adhesive layers used. The teeth were stored in distilled water for 7 days, followed by thermocycling with 500 cycles at 5ºC - 55ºC, with one minute in each bath. Thereafter, teeth were prepared for immersion in 0.5% methylene blue solution for four hours. The teeth were sectioned in mesiodistal direction for assessment of dye penetration. According to the results of the Kruskal-Wallis test, the three restorative materials employed did not completely avoid marginal leakage at the gingival margin of primary molars. The marginal leakage of PMCR F2000 (4.06 and 3.95) displayed to be higher than the marginal leakage observed for the materials Dyract AP (2.7 and 2.55) and Filtek Z250 (2.25 and 2.43). The number of adhesive layers did not influence the degree of leakage of the three materials.
Marginal leakage; Composite resins; Primary teeth
