Acessibilidade / Reportar erro

Evaluation of mechanical properties of Z250 composite resin light-cured by different methods

Avaliação de propriedades mecânicas da resina composta Z250 fotoativada com diferentes métodos

This study evaluated some mechanical parameters of Z250 composite resin using different light-curing methods. Ten specimens were prepared for each mechanical test group with different dimensions according to the test. Light-curing was performed by: a). continuous light (800mW/cm²-40s); b). exponential light (0-800mW/cm²-40s); c). intermittent light (2s-600mW/cm²; 2s without light-80s); d). stepped light (10s-150mW/cm²; 30s-650mW/cm²); e). PAC (1320mW/cm²-3s); f). LED (350mW/cm²-40s). After 24 ± 1 h, the specimens were loaded at a crosshead speed of 0.5 mm/min until fracture. The mechanical properties were calculated and analyzed by ANOVA and Tukey test (5%). The results showed that the highest compressive strength values were found for the continuous, exponential, intermittent and stepped light methods, whereas PAC and LED obtained the lowest values. LED, stepped light, PAC, exponential and continuous light presented the highest values for diametral tensile strength. The intermittent light showed the lowest value, which was significantly lower than the value obtained for LED only. Flexural strength results were not significantly different between all light-curing methods. Finally, the highest modulus of elasticity values were obtained for LED, exponential, continuous and intermittent light, whereas PAC and stepped light showed the lowest values. The mechanical properties were affected by light-curing methods employed.

Composite resins; Light-curing methods; Compressive strength; Diametral tensile strength; Flexural strength; Modulus of elasticity


Faculdade De Odontologia De Bauru - USP Serviço de Biblioteca e Documentação FOB-USP, Al. Dr. Octávio Pinheiro Brisolla 9-75, 17012-901 Bauru SP Brasil, Tel.: +55 14 32358373 - Bauru - SP - Brazil
E-mail: jaos@usp.br