SciELO - Scientific Electronic Library Online

vol.14 número6Avaliação em MEV do padrão de condicionamento do esmalte dental promovido por monômeros ácidos e o ácido fosfóricoEfeito do consumo de álcool no suporte ósseo periodontal em periodontite experimental em ratos índice de autoresíndice de assuntospesquisa de artigos
Home Pagelista alfabética de periódicos  

Journal of Applied Oral Science

versão On-line ISSN 1678-7765


NEPPELENBROEK, Karin Hermana et al. Bond strength of hard chairside reline resins to a rapid polymerizing denture base resin before and after thermal cycling. J. Appl. Oral Sci. [online]. 2006, vol.14, n.6, pp.436-442. ISSN 1678-7765.

PURPOSE: This study assessed the shear bond strength of 4 hard chairside reline resins (Kooliner, Tokuso Rebase Fast, Duraliner II, Ufi Gel Hard) to a rapid polymerizing denture base resin (QC-20) processed using 2 polymerization cycles (A or B), before and after thermal cycling. MATERIALS AND METHODS: Cylinders (3.5 mm x 5.0 mm) of the reline resins were bonded to cylinders of QC-20 polymerized using cycle A (boiling water-20 minutes) or B (boiling water; remove heat-20 minutes; boiling water-20 minutes). For each reline resin/polymerization cycle combination, 10 specimens (groups CAt e CBt) were thermally cycled (5 and 55 ºC; dwell time 30 seconds; 2,000 cycles); the other 10 were tested without thermal cycling (groups CAwt ad CBwt). Shear bond tests (0.5 mm/min) were performed on the specimens and the failure mode was assessed. Data were analyzed by 3-way ANOVA and Newman-Keuls post-hoc test (a=.05). RESULTS: QC-20 resin demonstrated the lowest bond strengths among the reline materials (P<.05) and mainly failed cohesively. Overall, the bond strength of the hard chairside reline resins were similar (10.09±1.40 to 15.17±1.73 MPa) and most of the failures were adhesive/cohesive (mixed mode). However, Ufi Gel Hard bonded to QC-20 polymerized using cycle A and not thermally cycled showed the highest bond strength (P<.001). When Tokuso Rebase Fast and Duraliner II were bonded to QC-20 resin polymerized using cycle A, the bond strength was increased (P=.043) after thermal cycling. CONCLUSIONS: QC-20 displayed the lowest bond strength values in all groups. In general, the bond strengths of the hard chairside reline resins were comparable and not affected by polymerization cycle of QC-20 resin and thermal cycling.

Palavras-chave : Shear strength; Acrylic resins; Denture liners.

        · resumo em Português     · texto em Inglês     · Inglês ( pdf epdf )


Creative Commons License Todo o conteúdo deste periódico, exceto onde está identificado, está licenciado sob uma Licença Creative Commons