When added to concrete in appropriate content, silica fume may provide an increase in the mechanical strength of the material due to its high pozzolanic reactivity. In addition to the chemical contribution, physical changes can also be observed in concretes with silica fume due to an improvement in the particle packing of the paste. This is a result of their small size spherical particles, which fill the voids between the larger cement grains. However, it is necessary to properly establish the cement replacement content by silica fume, because at high amounts, which exceed the volume of voids between the cement particles, silica fume can promote the loosening of these particles. Thus, instead of filling the voids and increasing the packing density, the addition of silica fume will increase the volume of voids, decreasing the solid concentration. Consequently, this will impair the properties of the concrete. The objective of this paper is to use a particle packing analytical model, the CPM (Compressible Packing Model), to verify the maximum packing density of cement and silica fume, which could be associated with the silica fume optimum content in pastes. The ideal content of silica fume in pastes, mortars and concretes is usually experimentally determined. However, a theoretical study to contrast experimental data may help understanding the behaviour of silica fume in mixes. Theoretical results show maximum amounts of silica fume in the order of 18 to 20% of the cement weight, which is high considering recommendations on literature of 15%. Nevertheless, the packing model does not consider the effect of silica fume high specific surface on the agglomeration of particles or water demand. Hence, the packing density predicted by this model cannot be used as the single parameter in determining the optimum amount of silica fume in pastes.
silica fume; packing of fine particles; wet packing; analytical model; CPM
