Acessibilidade / Reportar erro

Influence of column cross section and eccentricity of compression load in structural behaviour of two pile caps

Abstracts

To design of the pile caps are utilized the strut and tie model and bending theory. The Model Blévot and Frémy [1] is one of the models used to design of pile-caps. Another method for the design of caps is Model Beam that used bending theory. In the model of French researchers to cross section of the column is proportional to the cross section of strut near the column. To check the influence of the column cross section in the structural behaviour of the pile caps, experimental tests of the two pile caps were realized, varying the dimensions of the column and the high of the pile caps. Comparative analysis of experimental results with the results found by the Model Blévot and Frémy [1] was realized. It was observed that the increase of the column cross section conferred the pile caps greater strength capacity.

foundations; pile caps; experimental analysis


Para o dimensionamento de blocos sobre estacas utilizam-se geralmente os modelos baseados na analogia de escoras (bielas) e tirantes e teoria de flexão. O modelo de Blévot e Frémy [1] é um dos modelos de cálculo utilizado para o dimensionamento de blocos sobre estacas. Outro método para o dimensionamento de blocos sobre estacas é o modelo de viga que utiliza a teoria geral de flexão. No modelo dos pesquisadores franceses a seção transversal do pilar é proporcional à seção transversal da escora junto ao pilar. Para verificar a influência da seção transversal do pilar no comportamento estrutural dos blocos, realizaram-se ensaios experimentais de blocos sobre duas estacas, variando-se as dimensões da seção transversal do pilar e as alturas dos blocos. Análise comparativa dos resultados experimentais com relação aos resultados encontrados pelo modelo de Blévot e Frémy [1] foi realizada. Observou-se que o aumento da seção transversal do pilar conferiu aos blocos maiores capacidades resistentes.

fundações; blocos sobre estacas; análise experimental


Influence of column cross section and eccentricity of compression load in structural behaviour of two pile caps

R. G. Delalibera I ; J. S. Giongo I I

IDepartamento de Engenharia Civil (Departament of Civil Engineering), Universidade Federal de Goiás - Campus Avançado de Catalão, dellacivil@gmail.com, Av. Lamartine Pinto de Avelar, 1120, CEP: 75704-020, Catalão - GO, Brasil IIDepartamento de Engenharia de Estruturas (Departament of Structural Engineering), Escola de Engenharia de São Carlos, Universidade de São Paulo, jsgiongo@sc.usp.br, Av. Trabalhador Sãocarlense, 400, CEP: 13566-590, São Carlos - SP, Brasil

ABSTRACT

To design of the pile caps are utilized the strut and tie model and bending theory. The Model Blévot and Frémy [1] is one of the models used to design of pile-caps. Another method for the design of caps is Model Beam that used bending theory. In the model of French researchers to cross section of the column is proportional to the cross section of strut near the column. To check the influence of the column cross section in the structural behaviour of the pile caps, experimental tests of the two pile caps were realized, varying the dimensions of the column and the high of the pile caps. Comparative analysis of experimental results with the results found by the Model Blévot and Frémy [1] was realized. It was observed that the increase of the column cross section conferred the pile caps greater strength capacity.

Keywords: foundations, pile caps, experimental analysis.

Texto completo disponivel apenas em PDF.

Full text avaliable only in PDF.

REFERENCES

  • [01] BLÉVOT, J.; FRÉMY, R. Semelles sur piex. Analles d'Institut Techique du Bâtiment et des Travaux Publics, Paris, v. 20, n. 230, 1967, p. 223-295, fev;
  • [02] ASSOCIAÇÃO BRASILEIRA DE NORMAS TÉCNICAS. NBR 6118:2003 - Projeto de estruturas de concreto. Rio de Janeiro, 2004;
  • [03] COMITE EURO-INTERNACIONAL DU BÉTON. CEB-FIP, Recommandations particulières na calcul et à l'execution des semelles de fundations. Bulletin D'Information. Paris, n. 73, 1970;
  • [04] COMISIÓN PERMANENTE DEL HORMIGÓN. Ministerio de Fomento. Centro de Publicaciones. Instrucción española de hormigón armado (EHE). Madrid, 2007;
  • [05] CSA STANDARD A23.3-94. Design of Concrete Structures with Explanatory Notes. Canadian Portland Cement Association. Ontario, Canada, 2004;
  • [06] AMERICAN CONCRETE INSTITUTE. ACI 318-08 - Building code requirements for structural concrete, 2008.
  • [07] HOBBS, N. B.; STEIN, P. An investigation into the stress distribution in pile caps with some notes on design. Proceedings of the Institution of Civil Engineers., v. 57, pg. 559-628, 1957.
  • [08] MAUTONI, M. Blocos sobre dois apoios. São Paulo, Grêmio Politécnico, 1972.
  • [09] RAUSH, A.; ITURRIOZ, I.; D'AVILA, V. M. R. Análise experimental-computacional de um bloco de estacas de concreto armado. XXXIX Jornadas Sul-Americanas de engenharia estrutural, Brasília, 2000.
  • [10] MIGUEL, M.; TAKEYA, T.; GIONGO, J. S. Structural behaviour of three-pile caps subjected to axial compressive loading. Materials and Structural, v. 41, n. 1, pg. 85-98, 2007.
  • [11] CHAN, T. K.; POH, C. K. Behavior of precast reinforced concrete pile caps. Construction and Building Materials, v. 14, p. 73-78, Jan, 2000.
  • [12] ABEBAR, P. One-way shear strength of large footings. Can. J. Civ. Eng. 27: 553-562, 2000.
  • [13] SOUZA, R. A.; BITTENCOURT, T. N. Análise não-linear de blocos rígidos sobre quatro estacas. Revista Engenharia Civil, Universidade do Minho, Numero 21, 2004.
  • [14] DELALIBERA, R. G. Análise numérica e experimental de blocos de concreto armado sobre duas estacas submetidos à ação de força centrada e excêntrica. Tese (Doutorado). Escola de Engenharia de São Carlos, Universidade de São Paulo, São Carlos, 2006.
  • [15] DELALIBERA, R. G.; GIONGO, J. S. Influence of the pile´s rigidity on distribuition os stress in two pile caps. fib Symposium Dubrownik, Croacia, 2007.
  • [16] DELALIBERA, R. G.; GIONGO, J. S. Deformations in the strut of two pile caps. IBRACON Structures and Materials Journal, Vol. 2, 2008.

Publication Dates

  • Publication in this collection
    18 Sept 2014
  • Date of issue
    Dec 2009

History

  • Accepted
    15 June 2009
  • Received
    20 Nov 2008
IBRACON - Instituto Brasileiro do Concreto Instituto Brasileiro do Concreto (IBRACON), Av. Queiroz Filho, nº 1700 sala 407/408 Torre D, Villa Lobos Office Park, CEP 05319-000, São Paulo, SP - Brasil, Tel. (55 11) 3735-0202, Fax: (55 11) 3733-2190 - São Paulo - SP - Brazil
E-mail: arlene@ibracon.org.br