| | Table of contents
Cerâmica vol.51 no.319 São Paulo July/Sept. 2005 Editorial
| | | Utilization of ornamental rock waste from Northwest Fluminense in red ceramic
Moreira, J. M. S.; Manhães, J. P. V. T.; Holanda, J. N. F.
| | | Influence of grinding residual stresses on contact loading strength degradation in Y-TZP
Juy, A.; Anglada, M.; Fals, H. C.; Fernandez, J. B.
| | | Firewood ash for application in red ceramic. part I: characteristics of the ash
Borlini, M. C.; Sales, H. F.; Vieira, C. M. F.; Conte, R. A.; Pinatti, D. G.; Monteiro, S. N.
| | | Electrodialysis uses in Paraíba bentonite clay dispersions to eliminate Ca2+ and Mg2+ and its influence on rheology
Amorim, L. V.; Gomes, C. M.; Silva, F. L. H. da; França, K. B.; Lira, H. L.; Ferreira, H. C.
| | | Thermal properties of ceramic materials by non-steady state techniques: I - the laser flash technique
Santos, W. N. dos
| | | Microstructure and dielectric properties of dysprosium-doped barium titanate ceramics
Pu, Y.; Chen, W.; Chen, S.; Langhammer, Hans T.
| | | Effect of the glutaraldeide on the adsorption of proteic extract of the Ipomoea Batatas (L) Lam in analcime zeolite surface
Gondim, A. C. S.; Silva, L. R. D. da
| | | Effect of firing cycle on the technological properties of a red wall tile paste
Pinto, M. F.; Sousa, S. J. G.; Holanda, J. N. F.
| | | Optimization of mechanical strength of ceramic bodies as a function of raw materials and restrictions on technological properties
Correia, S. L.; Hotza, D.; Segadães, A. M.
| | | Effect of porosity on mechanical properties of a high purity alumina
Yoshimura, H. N.; Molisani, A. L.; Siqueira, G. R.; Camargo, A. C. de; Narita, N. E.; Cesar, P. F.; Goldenstein, H.
| | | Thermal behavior of rare earth modified PbTiO3
Lemos, F. C. D.; Longo, E.; Melo, D. M. A.; Silva, A. O.; Lima, F. J. S.; Silva, J. E. C.
| | | A new method to determine open porosity and permeability constants of open-pore sintered glasses by photoacoustic technique
Yasuda, M. T.; Melo, W. L. B.
| | | Mobility of interstitial oxygen in SmBa2Cu3O7-d ceramics
Nascimento, R. M.; Grandini, C. R.; Gimenez, J. M. A.; Cunha, A. G. da
| | | Sintering and second phase assignments in the SnO2-ZnO system
Sequinel, T.; Tebcherani, S. M.; Andrade, A. V. C.; Silva, J. C. Z.; Spagnol, P. D.; Cava, S.; Pianaro, S. A.
| | | Biomaterials based on Na2O-CaO-SiO2-P2O5 prepared with sawdust or corn glucose: effects on porosity and crystallinity
Campos, S. D. de; Campos, É. A. de; Silveira, C. B. da; Bini, R. A.
| | | SiCf /SiC composites for thermal protection systems
Florian, M.; Carvalho, L. E.; Iha, K.; Graça, M. L. A.; Cairo, C. A. A.
| | | Influence of the substitution of Y2O3 for CeO2 on the mechanical and microstructural properties of silicon nitride
Souza, J. V. C. de; Kelly, C. A.; Moreira, M. R. V.; Ribeiro, M. V.; Santos, C. dos; Silva, O. M. M.; Lanna, M. A.
| | | Influence of the synthesis method to obtain Na2TiSiO5 powders
Albarici, V. C.; Escote, M. T.; Orhan, E.; Lima, R. C.; Varela, J. A.; Longo, E.; Leite, E. R.
| | | Influence of vanadium on the morphological, structural and photoluminescent properties of zinc titanate - Zn2TiO4
Chaves, A. C.; Câmara, M. S. C.; Sales, L. L. M.; Araújo, A . G.; Santos, I. M. G.; Melo, D. M. A.; Longo, E.
| | | Synthesis and characterization of the system ZrO2-SiO2 with cobalt addition for use as ceramic pigments
Cava, S.; Tebcherani, S. M.; Pianaro, S. A.; Paskocimas, C. A.; Longo, E.; Varela, J. A.
| | | Investigation of the sintering kinetics for initial stage in SnO2: ZnO system
Kupchak, L.; Antunes, S. R. M.; Parizotto, M. V.; Tebcherani, S. M.; Setti, D.; Pianaro, S. A.; Antunes, A. C.
| | | Errata
| | |
|
All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License
