Resumo em Inglês:

BACKGROUND: A new fibrin adhesive made of buffalo plasma-derived fibrinogen and a thrombin-like snake venom enzyme, has been successfully used to immobilize free gingival grafts. This case series histologically compared sutured grafts (control group) with others immobilized by using the fibrin adhesive (experimental group). CASE DESCRIPTION: The grafts were placed in the contralateral mandibular bicuspids of 15 patients, so that each subject received one treatment of each type. Five biopsies of each group were collected at 7, 14 and 45 days of healing, which were histologically and morphometrically analyzed as regards the relative volume density of the different connective tissue components. RESULTS: The sites in the control group presented a higher inflammatory cell density at 7 days and a tendency towards a lower collagen density. In the experimental group, the grafts had an appearance of more advanced healing. Tissue maturity characteristics progressed until 14 and 45 days, but no difference between groups could be noted at these times. Conclusions: Within the limits of the present study, it may be suggested that the alternative fibrin adhesive tested could represent an alternative to sutures in gingival grafts procedures.

Resumo em Inglês:

From a biological standpoint, the best material for reconstruction of bone defects is the autogenous bone graft. However, as tissue healing is affected under diabetic conditions, major changes might take place in the revascularization, incorporation, replacement and remodeling phases of the grafted area. The purpose of this study was to assess the bone healing process in surgical wounds prepared in tibiae of diabetic rats and filled with autogenous bone. Forty male rats (Rattus norvegicus albinus, Wistar) were randomly assigned to receive an endovenous injection (penile vein) of either citrate buffer solution (Group 1 - control; n=20) or streptozotocin dissolved in citrate buffer solution (35 mg/kg) to induce diabetes (Group 2 - diabetic; n=20). After determination of glycemia, the animals were anesthetized and the anterolateral regions of the tibiae of both limbs were shaved, antisepsis was performed and longitudinal incisions were made in each limb. The tibiae were exposed and two 2mm-diameter surgical cavities were prepared: one in the right limb, filled with particulate autogenous bone and the other in the left limb, filled with blood clot. The animals were euthanized at 10 and 30 postoperative days. The anatomic pieces were obtained, submitted to laboratory processing and sections were stained by hematoxylin and eosin and Masson's Trichrome for histomorphologic and histometric analyses. In both groups, the wounds filled with autogenous bone graft showed better results than those filled with blood clot. The control group showed higher new bone formation in wounds filled with autogenous bone graft at 30 days than the diabetic group, but without statistical significance. It may be concluded that, in general, the new bone formation occurred with autogenous graft was quantitatively similar between control and diabetic groups and qualitatively better in the control group.

Resumo em Inglês:

This study proposed the development of a new clinical tool capable of quantifying the movements of opening-closing, protrusion and laterotrusion of the mandible. These movements are important for the clinical evaluation of the temporomandibular function and muscles involved in mastication. Unlike current commercial systems, the proposed system employs a low-cost video camera and a computer program that is used for reconstructing the trajectory of a reflective marker that is fixed on the mandible. In order to illustrate the clinical application of this tool, a clinical experiment consisting on the evaluation of the mandibular movements of 12 subjects was conducted. The results of this study were compatible with those found in the literature with the advantage of using a low cost, simple, non-invasive, and flexible tool customized for the needs of the practical clinic.

Resumo em Inglês:

The aim of this study was to compare the mechanical strength of different joints made by conventional brazing, TIG and laser welding with and without filling material. Five standardized joining configurations of orthodontic wire in spring hard quality were used: round, cross, 3 mm length, 9 mm length and 7 mm to orthodontic band. The joints were made by five different methods: brazing, tungsten inert gas (TIG) and laser welding with and without filling material. For the original orthodontic wire and for each kind of joint configuration or connecting method 10 specimens were carefully produced, totalizing 240. The fracture strengths were measured with a universal testing machine (Zwick 005). Data were analyzed by ANOVA (p=0.05) and Bonferroni post hoc test (p=0.05). In all cases, brazing joints were ruptured on a low level of fracture strength (186-407 N). Significant differences between brazing and TIG or laser welding (p<0.05, Bonferroni post hoc test) were found in each joint configuration. The highest fracture strength means were observed for laser welding with filling material and 3 mm joint length (998 N). Using filling materials, there was a clear tendency to higher mean values of fracture strength in TIG and laser welding. However, statistically significant differences were found only in the 9-mm long joints (p<0.05, Bonferroni post hoc test). In conclusion, the fracture strength of welded joints was positively influenced by the additional use of filling material. TIG welding was comparable to laser welding except for the impossibility of joining orthodontic wire with orthodontic band.

Resumo em Inglês:

OBJECTIVE: The aim of the present study was to determine the in vitro maximum inhibitory dilution (MID) of two chlorhexidinebased oral mouthwashes (CHX): Noplak®, Periogard®, and one polyhexamethylene biguanide-based mouthwash (PHMB): Sanifill Premium® against 28 field Staphylococcus aureus strains using the agar dilution method. MATERIALS AND METHODS: For each product, decimal dilutions ranging from 1/10 to 1/655,360 were prepared in distilled water and added to Mueller Hinton Agar culture medium. After homogenization, the culture medium was poured onto Petri dishes. Strains were inoculated using a Steers multipoint inoculator and dishes were incubated at 37ºC for 24hours. For reading, MID was considered as the maximum dilution of the mouthwash still capable of inhibiting microbial growth. RESULTS: Sanifill Premium® inhibited the growth of all strains at 1/40 dilution and of 1 strain at 1/80 dilution. Noplak® inhibited the growth of 23 strains at 1/640 dilution and of all 28 strains at 1/320 dilution. Periogard® showed inhibited growth of 7 strains at 1/640 dilution and of all 28 strains at 1/320 dilution. Data were submitted to Kruskal-Wallis statistical test, showing significant differences between the mouthwashes evaluated (p<0.05). No significant difference was found between Noplak® and Periogard® (p>0.05). Sanifill Premium® was the least effective (p<0.05). CONCLUSION: It was concluded that CHX-based mouthwashes present better antimicrobial activity against S. Aureus than the PHMB-based mouthwash.

Resumo em Inglês:

This study investigated the presence of human papillomavirus (HPV) DNA and viral types in 33 cases of oral squamous cells carcinoma (OSCC) and compared the immunohistochemical expression of the cell-cycle markers p21 and pRb between cases of the disease with and without HPV. DNA was extracted from paraffin-embedded tissue and amplified by PCR for the detection of HPV DNA. Viral typing was performed by dot blot hybridization. Immunohistochemistry was performed by the streptavidinbiotin technique. HPV DNA was detected in 11 (33.33%) of the 33 cases. The prevalent viral type was HPV 18 (81.81%). A significant association was observed between the presence of HPV and immunohistochemical expression of pRb, but not between p21 expression and the presence of the virus. The low frequency of detection of HPV DNA in OSCC suggests a possible participation of the virus in the development and progression of only a subgroup of these tumors.

Resumo em Inglês:

The aim of this study was to evaluate two root canal filling techniques used in teeth that had their apical foramen disrupted and compare the apical infiltration with an ideal clinical situation. Twenty-seven freshly extracted single-rooted teeth were selected and radiographed to confirm the existence of a single and straight root canal. The crowns were removed at a mean distance of 11 mm from the apex. The teeth had the root canals instrumented and were randomly assigned to 3 groups (n=9): ND group - root canals were filled using the lateral compaction technique and no disruption was performed; DRF group - the apical constriction was disrupted by advancing a #40 K-file 1 mm beyond the original working length, the canals were reinstrumented to create an apical ledge at 1 mm from the apical foramen and were obturated with a master gutta-percha cone with same size as the last file used for reinstrumentation; DF group - the teeth had the apical constriction disrupted and the canals were obturated with a master gutta-percha cone that fit at 1 mm from the apex. The teeth were submitted to dye leakage test with Rhodamine B for 7 days, using vaccum on the initial 5 min. The teeth were sectioned longitudinally and the leakage was measured in a linear fashion from apex to crown. There was no statistically significant difference (p>0.05) between the groups that had the apical foramen disrupted (DF, DRF), but significant difference was found between the disrupted groups and the non-disrupted one (p<0.01). In conclusion, none of the evaluated techniques was able to prevent apical infiltration, so working length so the working length determination has to be established and maintained carefully.

Resumo em Inglês:

This ex vivo study evaluated the quality of digital radiographic images obtained with the photostimulable phosphor plate system (Digora) according to the processing delay and maintenance of optical plates in either opaque (supplied with the system) or transparent protective plastic cases during this period. Five radiographs were obtained from the mandibular molar region of a dry human mandible using optical plates. These plates were placed in the protective plastic cases before obtaining the radiographs and were processed immediately or after processing delays of 5, 60 and 120 min, when the case was removed. The results revealed a reduction in image quality when processing was delay 120 min compared to the other times. The opaque case provided better protection to the sensor than the transparent case. In conclusion, a 120-min processing delay for the Digora system caused a reduction in image quality, yet without interfering with the quality of diagnosis. The opaque case supplied by the system's manufacturer provided better protection to the optical plate than the transparent case.

Resumo em Inglês:

This study evaluated in vitro the pulp chamber temperature rise induced by the light-activated dental bleaching technique using different light sources. The root portions of 78 extracted sound human mandibular incisors were sectioned approximately 2 mm below the cementoenamel junction. The root cavities of the crowns were enlarged to facilitate the correct placing of the sensor into the pulp chamber. Half of specimens (n=39) was assigned to receive a 35% hydrogen peroxide gel on the buccal surface and the other halt (n=39) not to receive the bleaching agent. Three groups (n=13) were formed for each condition (bleach or no bleach) according to the use of 3 light sources recommended for dental bleaching: a light-emitting diode (LED)laser system, a LED unit and a conventional halogen light. The light sources were positioned perpendicular to the buccal surface at a distance of 5 mm and activated during 30 s. The differences between the initial and the highest temperature readings for each specimen were obtained, and, from the temperature changes, the means for each specimen and each group were calculated. The values of temperature rise were compared using Kruskal-Wallis test at 1% significance level. Temperature rise varied significantly depending on the light-curing unit, with statistically significant differences (p<0.01) among the groups. When the bleaching agent was not applied, the halogen light induced the highest temperature rise (2.38±0.66ºC). The LED unit produced the lowest temperature increase (0.29±0.13ºC); but there was no significant difference between LED unit and LED-laser system (0.35±0.15ºC) (p>0.01). When the bleaching agent was applied, there were significant differences among groups (p<0.01): halogen light induced the highest temperature rise (1.41±0.64ºC), and LED-laser system the lowest (0.33±0.12ºC); however, there was no difference between LED-laser system and LED unit (0.44±0.11ºC). LED and LED-laser system did not differ significantly from each other regardless the temperature rise occurred with or without bleaching agent application. It may be concluded that during light-activated tooth bleaching, with or without the bleaching agent, halogen light promoted higher pulp chamber temperature rise than LED unit and LED-laser system. The tested light-curing units provided increases in the pulp chamber temperature that were compatible with pulpal health.

Resumo em Inglês:

Disturbances involving abnormalities in tooth eruption are named ectopia. Transmigration is the name assigned to ectopia in the presence of teeth in areas distant from the alveolar process. Initial angulation of the tooth bud of the second premolar and premature loss of permanent mandibular 1st molars can influence the distal migration of the second premolar. Some studies have observed that ectopic teeth can be found in a variety of places around the oral cavity and also in other areas of the human body. There are records of teeth in the maxillary sinus, mandibular condyle, coronoid process, mandibular angle, orbit, palate, mentum and also the skin. The prevalence of tooth abnormalities is higher in children with cleft lip and palate compared to children without clefts. This paper presents a case report of migration of the mandibular left second premolar in a patient attending the Hospital for Rehabilitation of Craniofacial Anomalies of the University of São Paulo (HRAC/USP), Brazil. Migration of the mandibular left 2nd premolar was confirmed by 8 panoramic and 1 periapical radiographs obtained during patient's treatment between 1978 and 2002, which were available in the files of the Department of Dental Radiology of HRAC/USP. It can be assumed that distal migration of the mandibular left 2nd premolar is not associated with presence of cleft lip and palate; observation of these two events in a same patient is rare, since no similar reported cases were found in the literature.