Recent studies involving the use of calcium aluminate cement (CAC) as a biomaterial are based on commercial products. Improvements can be attained by investigating the properties of their crystalline phases in order to better design the material's composition. Therefore, calcium aluminate phase samples immersed in simulated body fluid (SBF) solutions prepared according to Kokubo’s (KSBF) and Rigo’s (RSBF) methodology had their pH evaluated. The surfaces of these samples were analyzed by SEM, EDX and XRD techniques. The treatment with KSBF did not favor the precipitation of calcium phosphate phases on the surface of CAC phases. On the other hand, in RSBF solution, the pH value attained was higher than for the KSBF one and magnesium phosphate was identified on the surface of CA, C3A and C12A7 samples. Only for CA2, the optimal precipitation condition was attained in RSBF and a surface layer of the hydroxyapatite was detected. Based on its ability of stimulating hydroxyapatite deposition in SBF and other properties, CA2 can be eligible as the most suitable composition for biomedical purposes.

The aim of this study was to determine the best radiopaque additive to be incorporated to calcium aluminate cement (CAC) to promote radiopacity. Measurements of optical density were carried out on white MTA and CAC with and without additives such as: polymeric dispersant, plasticizer and various radiopacifiers. The effects of the radiopacifying addition on some properties of CAC were also evaluated. The radiopacity value for CAC-Bi2O3 (25%) was higher than the other radiopacifying agents tested. The addition of ZnO (25%) and 15%ZnO:10%Bi2O3 increased the compressive strength of CAC, whereas for Bi2O3 (25%) containing samples the strength was lower than for the CAC. The ZnO (25%) and 15%ZnO:10%Bi2O3 additions also reduced the apparent porosity. CAC does not have sufficient radiopacity to be distinguished from adjacent anatomic structures, such as dental tissues and bone. The addition of 15%ZnO:10%Bi2O3 can be suggested as the most suitable one to obtain the best compromise between good physical and mechanical properties and ideal radiopacity for clinical purposes.

O objetivo do presente estudo foi avaliar a progressão de cultura de células osteogênicas expostas a um novo cimento de aluminato de cálcio (CAC+) em comparação ao agregado de trióxido mineral (MTA). As células foram obtidas por digestão enzimática de calvária de ratos recém-nascidos, plaqueadas sobre lamínulas de vidro contendo em sua área central discos de CAC+ ou MTA e crescidas em condições osteogênicas por até 10 dias. Durante a cultura primária, observou-se o arredondamento das bordas das amostras de cimento apenas para MTA. Embora ambos os cimentos tenham permitido a adesão, o espraiamento e a proliferação celulares, as culturas crescidas em contato com CAC+ exibiram valores maiores de número total de células em 3 e 7 dias, e de conteúdo de proteína total e atividade de fosfatase alcalina em 10 dias. Os resultados indicam que a exposição ao CAC+ permite o desenvolvimento de uma proporção maior de células em estágios mais avançados da diferenciação osteoblástica, quando comparado ao MTA. Deve-se considerar em futuros estudos experimentais a utilização do CAC+ como um material alternativo ao MTA especialmente quando um dos objetivos do tratamento endodôntico é o de reparação dos tecidos mineralizados da região periapical.

The present study evaluated the progression of osteogenic cell cultures exposed to a novel calcium aluminate cement (CAC+) in comparison with the gold standard mineral trioxide aggregate (MTA). Cells were enzimatically isolated from newborn rat calvarial bone, plated on glass coverslips containing either CAC+ or a control MTA samples in the center, and grown under standard osteogenic conditions. Over the 10-day culture period, roundening of sample edges was clearly noticed only for MTA group. Although both cements supported osteogenic cell adhesion, spreading, and proliferation, CAC+-exposed cultures showed significantly higher values in terms of total cell number at days 3 and 7, and total protein content and alkaline phosphatase activity at day 10. The present in vitro results indicate that the exposure to CAC+ supports a higher differentiation of osteogenic cells compared with the ones exposed to MTA. Further experimental studies should consider CAC+ as a potential alternative to MTA when the repair of mineralized tissues is one of the desired outcomes in endodontic therapy.

Este estudo investigou a influência do alargamento cervical feito com diferentes instrumentos rotatórios na determinação do instrumento apical inicial (IAI) das raizes mésio-vestibulares de molares inferiores. Foram utilizados 50 molares inferiores cujas raízes mesiais apresentavam dois forames apicais nitidamente separados (mésio-vestibular e mésio-lingual). Após o acesso à câmara pulpar de forma convencional e remoção do tecido pulpar, o comprimento de trabalho foi definido a 1 mm do ápice radicular. Os dentes foram divididos aleatoriamente em cinco grupos (n= 10) de acordo com o tipo de instrumento utilizado no alargamento cervical. No grupo 1, o IAI foi definido sem o prévio alargamento dos terços médio e cervical das raízes. Nos grupos 2 a 5, o terço cervical e médio do canal radicular foi alargado com as brocas de Gates-Glidden, instrumentos Pro Taper, Endo Flare e brocas LA Axxes, respectivamente. A determinação do IAI foi realizada manualmente com limas tipo K em ordem crescente de diâmetro a partir da lima 08 até se chegar ao instrumento que permitisse ao operador ter a sensação tátil do mesmo estar firmemente ajustado ao CRT. O instrumento que correspondeu ao IAI foi fixado no interior do canal radicular com cianocrilato de metila. Com o IAI posicionado, os dentes foram seccionados transversalmente até 1 mm do ápice. As seções transversais do CRT foram observadas através da microscopia eletrônica de varredura e os desajustes entre o diâmetro do canal e o diâmetro do IAI foram calculados com a função "régua" (FEG) do software do próprio microscópio. Os resultados foram avaliados estatisticamente pelo testes de Kruskal-Wallis e Dunn ao nível de significância de 5%. Houve diferenças estatisticamente significantes entre os grupos (p<0,05). O grupo sem alargamento apresentou o maior desajuste (125,30 ±51,54) e diferiu significativamente dos demais grupos (p<0,05). O alargamento cervical com as brocas LA Axxess apresentou os menores desajustes (55,10 ± 48,31), seguido de EndoFlare (68,20 ± 42,44), Gattes Glidden (68,90 ± 42,46) e limas ProTaper (77,40 ± 73,19). Contudo, não houve diferenças estatisticamente significantes entre os instrumentos rotatórios (p<0,05). Conclui-se que o alargamento cervical melhorou a adaptação do IAI aos canais no CRT das raízes mésio-vestibulares dos primeiros molares inferiores. Os instrumentos rotatórios avaliados neste estudo não apresentaram diferenças estatísticas entre si no que diz respeito aos desajustes entre as dimensões do IAI e o diâmetro do canal no CRT.

This study investigated the influence of cervical preflaring with different rotary instruments on determination of the initial apical file (IAF) in mesiobuccal roots of mandibular molars. Fifty human mandibular molars whose mesial roots presented two clearly separated apical foramens (mesiobuccal and mesiolingual) were used. After standard access opening and removal of pulp tissue, the working length (WL) was determined at 1 mm short of the root apex. Five groups (n=10) were formed at random, according to the type of instrument used for cervical preflaring. In group 1, the size of the IAF was determined without preflaring of the cervical and middle root canal thirds. In groups 2 to 5, preflaring was performed with Gates-Glidden drills, ProTaper instruments, EndoFlare instruments and LA Axxes burs, respectively. Canals were sized manually with K-files, starting with size 08 K-files, inserted passively up to the WL. File sizes were increased until a binding sensation was felt at the WL and the size of the file was recorded. The instrument corresponding to the IAF was fixed into the canal at the WL with methylcyanoacrylate. The teeth were then sectioned transversally 1 mm short of the apex, with the IAF in position. Cross-sections of the WL region were examined under scanning electron microscopy and the discrepancies between canal diameter and the diameter of IAF were calculated using the tool "rule" (FEG) of the microscope's proprietary software. The measurements (µm) were analyzed statistically by Kruskal-Wallis and Dunn's tests at 5% significance level. There were statistically significant differences among the groups (p<0.05). The non-flared group had the greatest discrepancy (125.30 ± 51.54) and differed significantly from all flared groups (p<0.05). Cervical preflaring with LA Axxess burs produced the least discrepancies (55.10 ± 48.31), followed by EndoFlare instruments (68.20 ± 42.44), Gattes Glidden drills (68.90 ± 42.46) and ProTaper files (77.40 ± 73.19). However, no significant differences (p>0.05) were found among the rotary instruments. In conclusion, cervical preflaring improved IAF fitting to the canals at the WL in mesiobuccal roots of maxillary first molars. The rotary instruments evaluated in this study did not differ from each other regarding the discrepancies produced between the IAF size and canal diameter at the WL.