Sumário
Soils and Rocks, Volume: 50, Número: 1, Publicado: 2027Soils and Rocks, Volume: 50, Número: 1, Publicado: 2027
| Documents |
|---|
|
Article Efficiency of single piled raft units with short piles in compressible tropical soils Campos, Marcos Rodrigo Lopes Lopes, Alisson Filmiano Andrade Garcia, Jean Rodrigo Resumo em Inglês: Abstract This paper presents an experimental investigation on the behavior of single piled raft units installed in unsaturated lateritic soil representative of the Uberlândia region, Minas Gerais, Brazil. Static load tests were performed on circular raft foundations, both isolated and combined with bored piles measuring 4 m and 6 m in length. The load–settlement responses were analyzed to evaluate system stiffness, ultimate bearing capacity, and load-sharing mechanisms between the raft and the pile. The results show that raft contribution becomes more significant when piles are embedded in lower-strength soil layers, leading to substantial increases in overall bearing capacity. The configuration with a 4 m pile exhibited the highest overall system efficiency, with total capacity exceeding the sum of its isolated components by approximately 21%, whereas the 6 m configuration showed capacity essentially equivalent to the combined isolated elements, indicating that its main benefit lies in load redistribution rather than net capacity gain. Overall, the results indicate that the performance of piled raft systems is governed by the interaction between soil, raft, and pile, rather than by pile length alone. The use of short piles combined with raft foundations may represent an efficient solution under the investigated conditions, particularly for compressible tropical soils. |
|
Article Analysis of the stress-strain behavior of compacted rock block layers in shallow foundation Lemos, Bruna Leticia da Silva Dantas Neto, Silvrano Adonias Resumo em Inglês: Abstract In geotechnical engineering, using layers of compacted rock blocks has become a practical alternative for increasing soil bearing capacity, especially for shallow foundations. This study aims to analyze the stress-strain behavior of isolated (rectangular) footings supported on this type of material. For this, the Mohr-Coulomb shear strength parameters obtained through back-analysis (under axisymmetric conditions) of a plate load test performed during a preliminary geotechnical investigation were used. These shear strength parameters were applied in both analytical methods (using the GEO5 software) and three-dimensional numerical modeling (considering the state of three-dimensional stresses and strains) with the RS3 software, employing the Finite Element Method (FEM). The results demonstrated consistency between the approaches and confirmed that the layer of compacted rock blocks significantly enhances bearing capacity, redistributes stress, and reduces settlement. Therefore, this study provides a solid technical basis for adopting this geotechnical solution in shallow foundation projects. The comparison between analytical and numerical methods reinforces the reliability of back-analysis procedures for determining shear strength parameters. Additionally, the results indicate that this type of material can serve as a viable and sustainable alternative to improve foundation performance on low-capacity soils. The study also emphasizes the need for further research under different loading conditions and layer thicknesses to optimize design and deepen understanding of this construction system’s behavior in the field. |
|
Article Study on microgrid - strength parameters of the soil-geosynthetic interface based on direct shear tests Sena, Thiago de Sá Bessa, Ana Karine Santiago Soares, Anderson Borghetti Aguiar, Marcos Fábio Porto de Resumo em Inglês: Abstract Soil reinforcements positively influence the mechanical behavior of soil by inserting external elements, such as geosynthetics, which improve strength and reduce deformability of the composite. Over the years, new geosynthetics have been developed and upgraded. In the last decade or so, microgrids have emerged as an appropriate choice for strengthening and separating soil layers. This research aimed to evaluate the strength parameters of the soil‒microgrid interface using direct shear tests under different testing conditions and to compare the results with those for other geosynthetics (geomembrane and geotextile). The support base type (rigid and soil) for the geosynthetics was varied in the direct shear tests. When a soil base was used beneath the microgrid, performance was more efficient than with a rigid wooden base due to the higher soil friction angle. The results for all soil–geosynthetic interface strength parameters obtained using the rigid base indicated that the microgrid exhibited higher strength than the geomembrane and comparable strength to the geotextile, though slightly lower. |
|
Article Influence of wastewater treatment ettringite on the swelling of a soil stabilized with cement Sguarezi, Fernando Franco Benatti, Cláudia Telles Oliveira, José Renato Moreira da Silva de Lukiantchuki, Juliana Azoia Resumo em Inglês: Abstract The ettringite, a highly expansive mineral that is formed when the soil is chemically stabilized, can cause structural failures due to swelling and strength loss. This study addresses the gap in understanding the incorporation of industrial effluent treatment ettringite in the swelling of soils and soil-cement mixtures. The ettringite (WTE) was produced through the chemical treatment of aluminum wastewater supplied by an industry in Maringá, Paraná, Brazil. The experimental program was conducted using lateritic sandy soil and mixtures with 5% and 6% cement and/or WTE. The swelling and strength of the studied materials were assessed using free-swelling tests and unconfined compressive strength tests. Regarding the results, the resistance decreased by approximately 86% and 71% when 5% and 6% of WTE were added to the soil-cement, respectively. The swell values for soil-cement-ettringite increased up to 21 days without a stabilization trend, and the swelling was 50-60 times that of the natural soil. The cement releases sulfate ions; consequently, ettringite formation is promoted when both cement and ettringite are present in the mixture. |
|
Article Stabilization of a clayey soil from Mosul City with waste glass powder Alzaidy, Mohammed Nawaf Jirjees Faris, Mohammed Kamil Resumo em Inglês: Abstract Annually, large quantities of waste glass are being produced throughout the world; some of which are partially recycled, while most of which are conventionally disposed of in landfills. This situation necessitated the development of sustainable solutions for managing waste glass. Recently, extensive studies have investigated the use of waste glass as a sustainable additive to modify various soil types. This study presents the viability of utilizing waste glass powder (WGP) as a sustainable material tBo improve the physical and engineering properties of a low plasticity clay from Mosul City, Iraq, to moderate the cost of improvement and to offer a replacement for waste disposal, which creates an environmental problem in the solid waste disposal areas in Iraq. Initially, waste glass bottles were crushed, ground, and sieved through a #200 sieve, after which they were mixed with clay soil in different proportions. A series of physical and mechanical tests was done on the stabilized soil, including consistency, compaction characteristics, swelling potential, consolidation coefficients, and strength parameters. Results indicate that inclusion of WGP leads to a significant improvement in the maximum dry density, a reduction in the soil's tendency to swell-shrink, and an enhancement in the strength and consolidation parameters of the clay. Moreover, the optimal WGP percentage for improving this type of clay was approximately 10%. |
|
Technical Note Case study of Distributed Fiber Optic Sensors (DFOS) in the instrumentation of small-diameter bored piles subjected to tension and compression Barbosa, Yuri Silveira, Rodrigo Moraes da Buras, Marcelo Ramires Sobrinho, Rubens Futai, Marcos Massao Resumo em Inglês: Abstract This case study investigates the application of distributed fiber optic sensors for strain monitoring in small-diameter bored piles (D = 0.15 m, L = 3 m) subjected to compressive and tensile loading. A full-scale load test was conducted at the UFPR facilities where, simultaneously, one test pile was loaded in compression and two reaction piles were subjected to tension. The subsurface profile was characterized through a Standard Penetration Test, revealing stiff sandy clay and clayey silt layers. Instrumentation included electrical strain gauges installed at three depths and distributed fiber-optic sensing both in test and reaction piles. The optical fiber of the test pile was pre-tensioned to ensure adequate strain response under compression. Load-displacement curves indicated small settlements and primarily elastic behavior for all piles. For the test pile, comparisons of load transfer profiles derived from strain gauges and fiber optic measurements revealed good agreement at intermediate depths but discrepancies near the pile head and tip, largely attributed to temperature sensitivity and fiber bending effects. Reaction piles showed improved consistency between measurement systems, though early loading stages exhibited spurious negative skin friction in fiber-based results. Overall, the findings confirm the feasibility of using distributed fiber optic sensing in small-diameter bored piles, while highlighting installation-related factors that significantly influence measurement quality. |
|
Case Study The accident in the Awali tunnel (Litani hydroelectric scheme, Lebanon, 1950s): analyses and interpretations of more than 3 kilometres of tunnel flooded by sand and water Vaskou, Philippe Quadros, Eda Resumo em Inglês: Abstract This case study details a spectacular accident that occurred in a construction tunnel in the 1950s, fortunately without any fatalities. Located in Lebanon, the Awali tunnel was the main tunnel of a hydroelectric scheme along the Litani River, which also included a water intake, several tunnels, falls, and a powerhouse. The Litani hydroelectric development was characterised by its significant depth, reaching 1000 meters below the Lebanon mountain range, as well as its varied geological terrains, including sandstone. Even if the investigation carried out before the tunnel design and excavation had been rather limited, it has revealed the existence of poorly cemented layers within a major sandstone formation. As a result of this accident, over three kilometres of tunnel section were flooded and backfilled with sand. To our knowledge, it is the most devastating water impact in a tunnel, in terms of flow, pressure, and associated erosion. Applying principles of rock mechanics in structural and seismic tectonic environments enables us to understand the physical mechanisms underlying the accident’s origin and progression, in particular the interaction between natural stress and successive rock burst events. |
|
Case Study Malpasset arch dam: an example of major accident caused by the effect of water in a rock foundation Quadros, Eda Freitas de Vaskou, Philippe Resumo em Inglês: Abstract Malpasset dam accident is considered as the classical example of the detrimental effects of water in a rock foundation. Technically, it represents a unique case of arch dam collapse induced by the water and the subsequent uplift pressures acting on a very large rock wedge in a fractured rock foundation. At the time of the accident (1950’s), such an effect was totally unknown by the dam designers and geologists as well. After a summary of the background and geological context, the investigations and the design (initial and final one) are presented. Then, the chronology of events is reconstructed in detail, including the structural deformation of the arch during the filling of the reservoir and the heavy rainfalls. After all, the collapse is analysed based upon the observation carried out immediately after the accident as well as the post failure investigations that took place during the following years. Despite the total failure of the arch dam, the origin of the accident cannot be attributed to the dam structure itself but solely to the rock foundation. The accident of Malpasset lead to the creation of the International Society for Rock Mechanics (ISRM) in 1962 as well as main developments in engineering geology, hydrogeology, soil and rock mechanics. |
|
Case Study Deterministic design optimization for soil nail walls in a Brazilian highway construction Bommertz, Mélaine Anne-Fleur Halabi, Ana Luiza Mendes Siacara, Adrian Torrico Resumo em Inglês: Abstract Soil nail walls are widely used for slope stabilization in transportation infrastructure; however, their design still relies predominantly on manual, trial-and-error procedures or simplified Limit Equilibrium Method (LEM) analyses, which do not ensure optimality. Existing optimization studies are typically limited to idealized problems, lack integration with industry-standard Finite Element Method (FEM) tools, and rarely incorporate realistic construction stages or current design codes. This study addresses these limitations by proposing a fully automated Deterministic Design Optimization (DDO) framework that integrates the Sequential Least Squares Programming (SLSQP) algorithm with the commercial FEM software Plaxis 2D via Python scripting. The choice of Plaxis 2D enables rigorous simulation of soil–structure interaction, staged construction, and advanced constitutive behavior, while the scripting interface allows seamless automation, iterative model updating, and efficient exploration of the design space. The framework is applied to a real Brazilian highway case study, incorporating the requirements of the national standard ABNT NBR 16920-2. Optimization variables include nail length, face inclination, and total construction cost. Results demonstrate robust convergence and highlight the critical role of cost-based objective functions in achieving economically efficient designs. Validation against LEM analyses performed in Slide2 shows good agreement in factors of safety, with differences observed in predicted failure mechanisms. The proposed approach provides a practical, code-compliant, and scalable framework for automated geotechnical design, with significant potential for cost reduction in large infrastructure projects. |
|
Review Article Application of the dynamic replacement method in geotechnical soil improvement Souza Junior, Tennison Freire de Mohseni, Ana Paula Vianna Resumo em Inglês: Abstract Soils with low bearing capacity and/or high compressibility are widely encountered in both onshore environments — such as urban, industrial, and transportation infrastructure areas — and offshore settings in Brazil and worldwide. This widespread occurrence requires geotechnical interventions aimed at stabilizing and improving soil parameters and properties. Various ground improvement techniques are available, ranging from reinforcement and consolidation methods to compaction and stabilization approaches. Among them, the Dynamic Replacement (DR) method stands out as an effective solution for soft soils, organic clays, and similar deposits, through the partial replacement of the soil to be improved, using principles derived from dynamic compaction but applied to soil reinforcement. Currently, in Brazil, there is a relative scarcity of information available in the literature, as well as limited practical application in geotechnical works. Therefore, the present paper aims to provide a literature review addressing the fundamental concepts of Dynamic Replacement, as well as the equipment involved, monitoring and efficiency assessment procedures, existing numerical models, and representative case studies of the technique’s applications in Brazil and internationally. |
Leia a Declaração de Acesso Aberto
